Imdb

Yuku

Lefora

My account: Login | Sign Up

installing a torque converter | Topic profile

Topic profile page for installing a torque converter. This page has aggregated data from forum posts, threads, listings, online discussions, newsgroups, messageboards, and other online sources which contain user generated content for the term: installing a torque converter.

Topic "Installing a torque converter" was discussed 0 times on 0 sites in last 3 months

Search discussions, forums, images, videos, about "Installing a torque converter" on BoardReader!

BoardReader Tools

BoardReader Trendy!

Domain Profile

Posting activity graph on installing a torque converter:

Posts by: day week month

installing a torque converter was discussed on the following sites:

	Diesel Forum - The Diesel Stop.com - 14
	Ford Explorer, Explorer Sport Trac, Mercury... - 14
	FSB Forums - 12
	The 1947 - 1998 Chevrolet & GMC Pickup Message... - 11
	C6 Corvette Forum - 2005 Corvette, Pictures,... - 10

Related threads on installing a torque converter:

	Installing a torque converter??? Installing a torque converter???
	Installing a torque converter- something catching (1996 850) Installing a torque converter- something catching (1996 850)

Latest threads on installing a torque converter:

Installing torque converter

Started 2 months, 2 weeks ago (2009-10-16 09:23:00) by ford460

Ok, I am int he last stages of installing my new engine in my truck. I am installng the transmission now but before I install it I put the new torque converter in, while installing it I got the three clicks and it has judging by eye alittle more than a quarter inch inside the housing. I can take my hand and push up on it alittle and it will turn freely without binding. My question is do you ...

Source: FSB Forums

Forum: 1980-'96 Bronco's

Thread: Show this thread (3 posts)

Size: 834 bytes
Related Threads: Same Site | All Sites
Customize:

RE: Installing torque converter

Started 2 months, 2 weeks ago (2009-10-16 11:02:00) by Dustball

Sounds about right. Just keep spinning the converter while pushing in till it stops dropping in any further. The torque converter studs should be just a bit below flush with the bellhousing mounting surface. The converter will be free spinning, it doesn't "lock" into place. That's what a torque converter does- free spin until it reaches a certain rpm and then the higher the rpms, the ...

Source: FSB Forums

Forum: 1980-'96 Bronco's

Thread: Show this thread (3 posts)

Size: 543 bytes
Related Threads: Same Site | All Sites
Customize:

RE: Installing Torque Converter

Started 1 month, 2 weeks ago (2009-11-13 00:58:00) by SSedan64

Quote: Originally Posted by Chevy350Sb any ideas why It wont go into any of the gears? Are you sure the converter is installed correctly? Check fluid level after running it through gears? Did you have any clearance between the converter & flexplate before tightening the converter bolts? http://www.tciauto.com/Products/...

Source: Hotrodders Bulletin Board

Forum: Transmission - Rearend

Thread: Show this thread (14 posts)

Size: 1,158 bytes
Related Threads: Same Site | All Sites
Customize:

Hot threads on installing a torque converter: