Topic profile page for fj40.
This page has aggregated data from forum posts, threads, listings, online discussions, newsgroups, messageboards, and other online sources which contain user generated content for the term: fj40.
Topic "Fj40" was discussed 10,277 times on 199 sites in last 3 months
Started 1 day, 14 hours ago (2009-11-21 15:32:00)
by jtkyota
1973 Toyota FJ40 Landcruiser. 1980 model FJ40 2F engine, 1980 model transfer case and 4-speed transmission; 35" BFG mud terrain tires. Full soft top, bikini top. 4" lift kit. Good seats. Has rear bench seats and not factory jump seats. Have a factory heater and spare tire mount, but not installed. Does not have a tailgate or small half doors, however, I do have some small half doors that could be...
Started 2 days, 7 hours ago (2009-11-20 22:28:00)
by ampline
hello,, question guy here.. i need some advice regarding power steering... i have a 78 fj40 with a jim c 2f (that has an a/c compressor top/front driver side.... here in-lies the question)... a while ago i obtained all of the necessary power steering parts from a 79 fj40 to add power steering to my 40.. Parts include power steering pump, pulley, gearbox, shorter steering column and lines... i ...
Started 3 days, 14 hours ago (2009-11-19 15:49:00)
by KEEJEF
This 1977 fj40 landcruiser has been built from the ground up with no expenses spared. I will try and list all the things that have been done over the years to this vehicle but the pictures will tell the rest. A friend of mine started this restoration back in the late 80's - early 90's. During this time it was taken down to the frame and everything put back was new. The engine is a stroked ...
Started 4 days, 23 hours ago (2009-11-18 06:55:00)
by frontierjam
i have a 1975 fj40 and im changing the fluids in the transmission and i dont know what weight of hypoy fluids to put in it... i have be recommended 80w-90w but when we flushed the transmission the oil in it seams not as thick at the 80w-90w...
Started 5 days, 4 hours ago (2009-11-18 01:11:00)
by Pistorman
Hello there. After probably two years thinking about it, I finally went ahead and bought a 1970 FJ40 from a man in Winnsboro, LA. I bid on it on eBay and eded up buying it for $3,550.00 the car does not seem to have over 100K. The engine sounds and starts pretty well. The car was kept in Colorado for most of its life, with a horrible almost agonizing ending in Louisiana (with all due ...
Started 6 days, 5 hours ago (2009-11-17 00:41:00)
by lynchmob
Here is Kate. This is a 78 FJ40 built up by the late Butch Lewis and currently belongs to PacToy. In the coming weeks this 40 will be getting a 12HT and 5 speed. Ill post more later in the week.
Started 6 days, 6 hours ago (2009-11-16 23:14:00)
by tebby
Does anyone here own a vintage FJ40. I'm trying to help my dad out and sell a couple FJ parts...just don't know what the hell they are or what they're worth. I'd like to email pics to find out what he has so I can list em on ebay. If you're willing to give me a couple minutes of your time please PM me your email...thanks...j
Started 6 days, 17 hours ago (2009-11-16 12:46:00)
by Torque
I purchased a set of 5 white OEM wheels and had them sand blasted and powder coated white. They appear to be a shade (or two) whiter than the original wheels, but they look great. The top of my 1982 FJ40 (color code 033) appears to be the same color of the body an not a whiter color (see picture below). Is this correct or is it likely a PO repainted the top to match the creamy off-white of the...
Started 1 week ago (2009-11-15 21:59:00)
by vegas702
I have an FJ40 FST, made in '66 and registered in '67. Did the '66 have a rear heater? It appears that I have a coolant hose that has been plugged, and there is an empty bracket below it. But I didn't think that the '66 had a rear heater.
Started 1 week ago (2009-11-15 21:25:00)
by Bostonfj60
So I'm trying to figure out what to do for sliders on the 40. I like this sort of design from 4 Plus: 4+Plus FJ40 Rock Sliders W/Step I like the stock look of these, but I'm concerned about mounting sliders on the body. With the 60, I had body mounted sliders which worked awsome 95% of the time, until I slide off a rock sideways, and with no support from the inside, it bent the ...
Started 1 week ago (2009-11-15 14:00:00)
by steenh
30 minute long "commercial" for Porsche where they are rolling out the new Panamera. Pretty interesting (no great though). All Porsches throughout the documentary except for one guy who drives out of his garage in a nice FJ40 on his way to rock climbing. Thought it was interesting that a 40 would make it in a P commercial! Says a lot! Land Cruisers and Porsches... best you can get!...
Started 1 week, 1 day ago (2009-11-14 16:57:00)
by FrankF
After a ton of help, thanks, the new fuel pump is not bringing any fuel from the full tank to the filter. I am going to now tank the tank out, have it refurbished (unless anyone has a good clean one for sale) clean out all lines leading to fuel filter and hope that is the answer to why my 40 still will not start. I have replaced the rubber lines to filter, new filter, new line to new fuel pump ...
Started 6 days, 17 hours ago (2009-11-16 12:14:00)
by RufusTheDufus
I asked this question over in the 45 section but figured I'd ask here too. I need to replace the two front rusted floor sections in my RHD 1980 HJ45 Troopy. I tried to order them from IPOR today and they said the 40s were different than the 45s. I thought the whole front tub section was the same on a 45 Troopy as a 40/42 series. Anyone done this fix and have experience with it?
Started 6 days, 21 hours ago (2009-11-16 08:36:00)
by costajamon
I have a 91 GMC K2500 4x4 that I have recently replaced just about everything there is to replace on it. If I sold it now I would be throwing like 5 grand away. Cosmetically she's not perfect but pretty rugged. Yet, I still have a few things to do, and I admit I'm no professional mechanic, though I have a high school votech degree. I never learned much about transmissions, transfer cases, ...
Started 1 week ago (2009-11-16 02:06:00)
by Dusty's 66
Newby checking in first post My name is Joe Im kinda of an old guy bought my first 4X4 in 1976 a 71 Fj40 have owned mostly Land Cruisers since. running the Desert back roads ever since. My wife & I are hopelessly addicted to adventure & camping, hot springs,backpacking and just exploring the west we live in Las Vegas, Nv Current rig are 2007 FJC 6 speed no mods wife trip Rig My ...
Started 1 day, 10 hours ago (2009-11-21 19:33:00)
by Justaguy
Hi y'all, I hail from the frozen north. Today its about -30F. My name is Dan. I really enjoy my family, snowmachining, and somehow staying warm. I own an F250 with a diesel, a '73 fj40, '66 cj5, '99 D150 4x4.
Started 1 week, 1 day ago (2009-11-14 19:35:00)
by BigSur
I need to replace my rear motor/tranny mounts and besides OEM where else can i get some? Napa, autozone, Oriellys'? This is for my 02/80 Fj40. What kind of issues will i run into if i don't go OEM? Jason
Started 1 week, 1 day ago (2009-11-14 13:47:00)
by Chipcraft
I'm going to purchase a new radiator for my FJ40. It has a small block chevy 400. I've looked at a few online and am leaning twards this 4+Plus model from Manafre with the tranny cooler option, mount and fan shroud. http://www.man-a-fre.com/parts_acces...4plusmount. htm Has anyone used this one? if so how does it work? Alternate recommendations? thanks, Mike
Started 1 week, 1 day ago (2009-11-14 14:54:00)
by Slow Poke
I have a 77 fj40. Factory seats rebuilt with SOR seat covers and new fitted bottom foam. The problem I'm having is that the seat runners are physically too wide. From center to center I'm 20 1/8 side to side on the seat. The mounting brackets are 19 5/8 center to center. There is some play in the openings allowing for some offset, but with a center console that I have from CCOT it's just not ...
