Topic profile page for Water Flow.
This page has aggregated data from forum posts, threads, listings, online discussions, newsgroups, messageboards, and other online sources which contain user generated content for the term: Water Flow.
Topic "Water flow" was discussed 6,240 times on 1,115 sites in last 3 months
Started 1 day, 15 hours ago (2009-12-03 08:00:00)
by Brownjamesa
Hi, I have had a couple of plumbers around to quote me for a new bathroom and to install and new en-suite and have asked them what do i need to have in installed to be able to run two showers at the same time for a maximum of 5 mins. Both of them have recomended a megaflow, but they did not check my mains water presure/flow? I know I have a 15mm mains comming in from the ...
Started 1 day, 19 hours ago (2009-12-03 04:17:00)
by Stephany McDowell
Beyonce is Sasha Fierce with her inspirations to keep the Satellite Former Soviet Republics Family Forever. Here are her lyrics to her song: Satellite. From the depths of her heart, Satellite: Satellites Flashing by It's a beautiful state were in But how can we love in isolation Think how happy we can be When we just try When nothing like we seem Passion in words are never spoken You don't know...
Started 3 days, 7 hours ago (2009-12-01 16:09:00)
by jchase1970
For a reef tank how much flow show be idea. I've seen it taid more is better, but I have also seen that 2 much can hurt somethings. Also do you figure the total gals of the whole system or just the size of the display tank?
Started 6 days, 10 hours ago (2009-11-28 13:24:00)
by tim45z10
A friend of mine said his hot water does not flow as freely as the cold in all of the faucets. The heater is not that old. Any thoughts on a cause? Thank you for your input.
Started 1 week ago (2009-11-27 16:24:00)
by mercer2773
Hi, I have a problem with my single lever 'Roca' bathroom tap , the flow of water coming out is quite slow and when i move lever to the hot position i get no hot water. the boiler does not attempt to start up !! I have a Alpha 240 eco combi boiler which heats the water. when i operate the bath tap, also a single lever type the water flow is fine. and it produces hot water, also the shower ...
Started 1 week, 2 days ago (2009-11-25 19:32:00)
by Bren
Our CH boiler has stopped heating water for the household taps the CH is still working normally. The symptoms are as follows:- 1. Turned of the ch and turned on hot tap it did not switch inself on but initially got a small amount of hot water. Did it again and this time just cold but again it did not switch itself on. 2. Switched on ch and waited until boiler not running, turned on ...
Started 1 week, 6 days ago (2009-11-21 10:46:00)
by SkiprJohn
Anyone have a system that checks electronically to see if you are getting enough raw water to engine or genset or watermaker? If so, what kind and how does it work? regards
Started 2 weeks ago (2009-11-20 16:24:00)
by Kozure
http://web.mac.com/kozureokame/Jacek_Jurczynski/Bl og/Entries/2009/11/21_Water_flow_files/nippon_paz_ 2009_4426_1.jpg Shot at Senjogahara marsh. You can find more photos from Senjogahara on my blog. Let me know what you think. Thank you.
Hi all, Just had a call from the in-laws, they have no hot water flow to their bathroom basin mixer tap this morning. The flow to that particular tap has always been pretty rubbish. The system is a conventional open vent storage cylinder. Having a look around on here, the problems seem to centre around, 1. Air lock (doubt it's this as there has been some flow and no...
Started 1 week, 1 day ago (2009-11-26 21:06:00)
by Geoff
In message , Bren writes "Mathew Newton" wrote in message ... On 25 Nov, 18:32, "Bren" wrote: A friend reckons we need to replace the cold water flow switch. What do you think? Most likely a perished diaphragm in the diverter valve. I documented my own such repair at http://www.newtonnet.co.uk/house/boiler/ if you want an idea of what's involved. I receive ...
Started 1 day, 1 hour ago (2009-12-03 21:59:00)
by transam
for unvented cylinders I would expect a min of 1 bar dynamic or running pressure , & a min flowrate of 20 litres a min ', your flowrates are at the min' i would go with storage . you could of course use an accumulater with an unvented cylinder , which is a way of storing mains water .
Started 1 week ago (2009-11-27 18:17:00)
by mercer2773
kevplumb wrote : not if its below the flowrate the boiler fires at minimum rate for your boiler is 2.5 lpm Thank you for help and advice kevplumb. regards
Started 1 day, 14 hours ago (2009-12-03 09:38:00)
by Metallisteve
NCGS 156-24 gets close to a bull's eye, but misses the perfect mark (as do many of the statutes in 156). Most of the statutes specifically call out a swale, canal, or ditch...none of which typical overland sheet flow ("runoff") can be described as. This gives a foothold for someone to wiggle out from underneath the provisions of that statute. The closest one I can find is 156-25: Quote:...
