Topic profile page for Transaxle.
This page has aggregated data from forum posts, threads, listings, online discussions, newsgroups, messageboards, and other online sources which contain user generated content for the term: Transaxle.
Topic "Transaxle" was discussed 7,848 times on 530 sites in last 3 months
Started 1 day, 11 hours ago (2009-12-05 11:22:00)
by bajabugman
I am looking for parts/tools for a 901 transaxle because I am in the middle of a rebuild. I need: 1st gear dog teeth 1st gear slider bearings for the intermediate plate syncro hub removal tool I am looking for either new or in good used condition parts/tools. Please leave me a personal message if you have these. Thanks in advance.
Started 1 week, 3 days ago (2009-11-26 06:38:11)
by greengo
This is the place I had build a transaxle for my latest build. It may be of help to some. Not cheep but GOOD. Ron's Transaxles Superior Volkswagen and Porsche Transaxles My name is Ron Jones and this is my web site. I run a Transaxle Rebuild service that is second to none...
Started 1 week, 4 days ago (2009-11-25 09:53:00)
by braino
decent condition. Came from a Florida car. Brake calipers are a bit rusty but the transaxle itself was rebuilt by the PO and has low miles. In Berkeley CA. $150 obo
Started 2 weeks, 2 days ago (2009-11-20 03:07:00)
by Red Devil
I have a leak on my transaxle/gearbox and as I am removing it to POR 15 under the bus and carry out a couple of other jobs I thought I should look to rectify this leak. It has been suggested that I should replace all the gaskets whilst it is off the bus. My question is in order to repalce the large hexagonal type paper gaskets where the axle goes into the gearbox do I have to remove the axle ...
Started 3 weeks, 1 day ago (2009-11-14 16:39:00)
by orange4boy
Just about to start the replacement of the toast transaxle on my 2003. I bought it like this for a song and now I have to do the dance. It was run dry from a slow leak and I have found a low mileage replacement in Edmonton which should arrive Monday or Tuesday. Car has about 104k miles / 168000 km and is in very good shape otherwise. The search for the transaxle is documented in: How ...
Started 3 weeks, 2 days ago (2009-11-13 15:54:00)
by mrxios
1993 Eclipse 2.0 non-turbo FWD My friend just got this car and we noticed both bolts that attach this bracket to the transaxle are missing. Does anyone have the specs for these bolts? The bracket is the one on the passenger side, below battery, one side of bracket is attached to wheel well, it has a large rubber bushing. The two bolts that are missing are the ones that go through ...
Started 3 weeks, 3 days ago (2009-11-12 13:35:00)
by megsaturn
What's the difference? I had a gear head friend tell me that since I have a transaxle that it'd make changing the tranny fluid more difficult. It was easy as pie. Any help as to why it would be harder to change?????
Started 3 weeks, 6 days ago (2009-11-09 21:32:00)
by 99 VR4
I am ready to remove my transaxle, I have all the pre-removal completed and am looking to see if anyone has removed it without a transmission jack.....and if so what is the best way.....also how many bolts hold the transaxle case to the engine. Pete
Started 3 weeks, 6 days ago (2009-11-09 16:44:00)
by ToyotaHankins
My left cv joints have packed it in so I'm going to have to replace them. I was thinking while I had the driveaxle out I should replace the transaxle oil seal also. It's not leaking now but its happened before as soon as I disterb something it will start to leak. Has anyone else replaced this seal? Had any problems? It seems straight forward. Also is that a special seal driver for it? Thanks...
Started 4 weeks ago (2009-11-08 19:17:00)
by bora450
FS: Center console gauge panel for three gauges, 2-1/6" diameter. Mounting screws included. $10 or trade for the cubbyhole that it replaces. (TRADED) FS: Transaxle Mount. $10
So when I was driving around town this happened. There was a "thud" and this light came on, pulled the car off the road let it run for a few and it seemed okay. Then it did it again after about 5 miles or so, a thud and the light flickered for about a sec. What the heck does this mean?? All the owners manual says if the light comes on while driving have the car serviced. My Focus has 28,7XX on it...
Started 6 days, 11 hours ago (2009-11-30 11:23:00)
by ovsa
been searching high and low for some DIY info on removing and replacing the axles on my 2001 jetta wolfsburg. Can anybody direct me to a link and let me know which speciality tools are required if any? Shoud i do both sides even if only the driver's side is the bad one? It sounds like the CV is bad but i have read that it is eaier and cheaper to replace the whole axle assembly. Is this right...
So when I was driving around town this happened. There was a "thud" and this light came on, pulled the car off the road let it run for a few and it seemed okay. Then it did it again after about 5 miles or so, a thud and the light flickered for about a sec. What the heck does this mean?? All the owners manual says if the light comes on while driving have the car serviced. My Focus has 28,7XX on it...
Started 6 days, 20 hours ago (2009-11-30 02:29:00)
by 96ToyoCam164K
I was just looking at the recommended maintenance for my 96, 4 cylinder and seems like I have never had the transaxles replaced (since I bought it at 133K) which is recommended at every 15k for normal use. Is that differential fluid? I know its not transmission fluid right I went to my mechanic today and was told that I dont have differential fluid. I hate to seem like Im wanting to get ...
Started 5 days, 13 hours ago (2009-12-01 08:57:00)
by Nifski
I have a chance to pick up a clean pan for my 54'. my question is about the number on the front E-Brake tab, is it suppose to match the pan number on the transaxle hump? If not, what is the number?
Started 1 week ago (2009-11-29 07:10:00)
by Dave S
Hey Guys Does anyone have a spare clutch lever fork and slave cylinder for an Audi 016 transaxle. I recently got an 016 but was not aware these parts had been removed from the gearbox.
Started 1 week ago (2009-11-29 17:51:00)
by Ian 951
I have a Porsche 944 turbo 016R AOR LSD Transaxle assy with oil cooler, clutch, Torque Tube assy, complete axle assy less shocks, calipers and shifter FOR SALE. Also have 1, 2.5l block (needs reboring) & Crank (is ok). The items are in Fareham, U.K. I want 800 GBP for the lot. Previous owner says Transaxle has swepco fluid but i haven't checked it. Items are out of a car with wrecked front...
Started 1 week ago (2009-11-29 22:24:00)
by ziggy414
I was pulling the cv axle on the driver's side of my son's 93 mx6LS - after releasing the outer CV from the hub we tried to pop the inner away from transaxle. The axle shaft and joint came completely out of the CV-Joint and now the cup is stuck in the transaxle and I can't get it out. I have bent one prybar and used a long cheater on another with no success...but no luck. Any Ideas...Please help,...
Started 4 days, 23 hours ago (2009-12-01 23:10:00)
by ziggy414
I have a 93 Mazda MX6 LS V6 - Driverside inner cvaxle is stuck in the transaxle. I have bent two 24" prybars...beat the you know what out of it. With no luck. There is very litle room, only one place I can even get a prybar in. One mechanic friend told me I may have to pull the other side and use a punch from the opposite side. I am not sure it will even be open to do that. I would appreciate any...
Started 4 days, 3 hours ago (2009-12-02 19:33:00)
by kevinkjl
I will be replacing my 3VZ engine on my ES300 this weekend and the manual says it should come out with the transaxle. I would have to remove the halfshafts (drive) to do this. Is it possible to remove only the engine?
Started 3 days, 22 hours ago (2009-12-03 00:41:00)
by Mr. Movida
The front wheel transaxle on my '91 Trooper II is held in the hub by a snap ring (you'd think something a bit more substantial but yep it's a snap ring). My left front hub transaxle has popped the snap ring off and retreated back into the inside of the hub. I have tried using a bolt to pull the axle out to put the snap ring back on (you fit a bolt into the end of the axle...
