Rawlplug - forum posts

Started 1 month, 3 weeks ago (2009-10-26 19:17:15) by Victor Martin

Removed the mirrors and plastic base for painting . I found it difficult to remove the base and ended up breaking off the two plastic pieces that the screws go into. Looks like a rawlplug, but attached to the base( all one piece). So any suggestions on remounting the bases, I been thing of rivets. I think the hole is 3/16 ? Thanks Victor

Source: Spitfire Magazine BBS

Forum: Body

Thread: Show this thread (10 posts)

Size: 341 bytes
Related Threads: Same Site | All Sites
Customize:

Drilling into Polyfilla?

Started 1 month, 3 weeks ago (2009-10-26 18:11:00) by eightyfish

Hi. I am attempting to hang a large and heavy bathroom cabinet onto plasterboard walls. One of the drill holes became too big and the rawlplug is loose. I have filled it with Polyfilla and intend to re-drill when it's properly set tomorrow. Does anyone know if this is possible? Thanks.

Source: boards.ie

Forum: Gardening & DIY

Thread: Show this thread (11 posts)

Size: 320 bytes
Related Threads: Same Site | All Sites
Customize:

I hope whoever did this also did the lottery that week I hope whoever did this also did the lottery...

Started 2 months, 2 weeks ago (2009-10-01 16:35:00) by mbelectric

Went to price up some bathroom work where the room had been gutted. Going up the centre of the wall (previously tiled) was some capping with a rawlplug right through the middle, behind the capping was 1 x 2.5 and 2 x 1.5 so it must have been a tight fit getting them all in there in the first place. Somehow the drill bit managed to find a way through just nicking the outer insulation of all 3....

Source: DIYnot.com Forum

Forum: Electrics UK

Thread: Show this thread (5 posts)

Size: 1,586 bytes
Related Threads: Same Site | All Sites
Customize:

RE: Mark I had a similar problem with a plasterboard wall, you might find just by drilling into the tile...

Started 2 weeks, 6 days ago (2009-11-30 12:19:00) by woody007

Source: DIYnot.com Forum

Forum: Tiling

Thread: Show this thread (12 posts)

Size: 862 bytes
Related Threads: Same Site | All Sites
Customize:

RE: fitting pedestal sink to wall

Started 4 days, 4 hours ago (2009-12-16 13:29:00) by Chukka63

Pig Tails ?? http://www.screwfix.com/prods/81139/Fixings/Cavity -Fixings/Rawlplug-Self-Drill-Plasterboard-Fixing-M etal-32mm-Pack-of-100

Source: DIYnot.com Forum

Forum: Plumbing and Central Heating

Thread: Show this thread (10 posts)

Size: 518 bytes
Related Threads: Same Site | All Sites
Customize:

RE: anything better than a Molly Screw? - Page 2 - DIYbanter

Started 5 days, 7 hours ago (2009-12-15 10:33:00) by Mike Clarke external usenet poster

jsabine wrote: This might make it a bit tricky to get it to expand by screwing (oiling the threads might help) but a setting tool for these things is well worth getting if you need to fix more than a few things to plasterboard. Screwfix sell the Rawlplug setting tool http://www.screwfix.com/prods/92462 They also do a setting tool for under a tenner - #12429 - and at that...

Source: DIY & home improvement forum - DIYbanter

Forum: UK diy

Thread: Show this thread (17 posts)

Size: 1,873 bytes
Related Threads: Same Site | All Sites
Customize:

RE: fixing a heavy wood framed mirror to a dotdab wall

Started 1 week, 2 days ago (2009-12-10 22:24:00) by paul w

I have recently put my new kitchen into extension i built,walls were thermalite blocks 10mm void dot and dab plasterboard,i did a few experiment with various fixings and the wall units were very heavy and i settled on using these Rawlplug Frame Fixings 8 x 100mm Pack of 50 - Screwfix.com, Where the Trade Buys I drilled a 7.5mm hole,cut the collar off the plastic sleeve and tapped ...

Source: ScoobyNet - Subaru Impreza Community Forums

Forum: DIY

Thread: Show this thread (7 posts)

Size: 825 bytes
Related Threads: Same Site | All Sites
Customize:

RE: Picture hanging products, where to buy in Munich

Started 2 weeks ago (2009-12-06 00:00:00)

Picture hanging products, where to buy in Munich - Toytown Germany Jump to content...

Source: Toytown Germany chat forum

Forum: Life in Munich

Thread: Show this thread (2 posts)

Size: 52 kb
Related Threads: Same Site | All Sites
Customize:

RE: Pergolas - frameworks for climbing plants

Started 2 weeks, 3 days ago (2009-12-03 00:00:00)

Pergolas - frameworks for climbing plants - Toytown Germany Jump to content...

Source: Toytown Germany chat forum

Forum: Miscellaneous

Thread: Show this thread (2 posts)

Size: 42 kb
Related Threads: Same Site | All Sites
Customize:

RE: metal rawl plug hooks

Started 2 weeks, 4 days ago (2009-12-02 17:03:00) by ART6

Quote: Originally Posted by paddles i bought these hooks to hang a mirror up. followed the instructions and bore an 8mm hole in wall but it seems too big! i don;t understand how the rawl plug thing is meant to work either now that i see it. seems u twist the hook and it grips the wall. bit dodgey and wondering if these metal type rawl ...

Source: boards.ie

Forum: Gardening & DIY

Thread: Show this thread (10 posts)

Size: 2,609 bytes
Related Threads: Same Site | All Sites
Customize:

RE: Welcome to The BCal Forum

Started 3 weeks, 1 day ago (2009-11-28 04:16:00) by jonn1

comment2, [url=http://rosemarieshavanese.com/photogallery/ph oto2629/favor_ite_.html]mamadas com[/url], ctvgu, [url=http://foreverworkingmom.com/language/ind_ex3 .html]lds nativity clipart[/url], zup, [url=http://www.scubadivinginternships.com/_border s/pa_di_underwater_navigator_specialty__divers_cou rse.html]website like shufuni[/url], pmqs, [url=http://www.sbbsconsulting.com/blowjob/baruto- ...

Source: bcal.websitetoolbox.com

Forum: bcal.websitetoolbox.com

Thread: Show this thread (1144 posts)

Size: 1,047 bytes
Related Threads: Same Site | All Sites
Customize:

Rawlplug | Topic profile

Posting activity graph on rawlplug:

Related topics:

rawlplug was discussed on the following sites:

Related threads on rawlplug:

Latest threads on rawlplug:

Hot threads on rawlplug: