Topic profile page for G22.
This page has aggregated data from forum posts, threads, listings, online discussions, newsgroups, messageboards, and other online sources which contain user generated content for the term: G22.
Topic "G22" was discussed 0 times on 0 sites in last 3 months
Started 1 day, 5 hours ago (2009-12-20 13:15:00)
by fr8owner
I just picked up a thousand rounds of brass and bullets for my g22. I am looking to reload for it but want to get an aftermarket barrel for it as to extend the life of my brass. I have tried a lot of the retailers on here and nobody has anything (or at least what i am looking for) in stock. Does anybody know where i can find a stock length standard 40 cal non conversion g22 barrel? ...
Started 1 day, 22 hours ago (2009-12-19 20:15:00)
by FiremanJim
My Wife's G22 service pistol has had a lasermax site installed for a few years,her department is not allowing them to be used any more,problem is I cannot seem to find her stock G22 guide rod and spring.My question is can I use the guide rod and spring from her G17 in her G22 Service pistol?Figured I could throw the Lasermax in the 17 and all will be good but I figured I better ask...
Started 4 days ago (2009-12-17 18:46:00)
by bno762
I have a stock length barrel for a g22 made by lonewolf dist. for sale. Asking $65 shipped in the lower 48 states. Payment by postal M.O.. Its been used but doesn't have more than 500 rounds thru it. The chamber was opened up a little bit to aid feeding with handloads. pm me or e-mail to bno762@aol.com I will consider trade offers of Benchmade, Emerson, or Spyderco knives also.
Started 1 week, 1 day ago (2009-12-13 15:23:00)
by BoomerG20
4 G22 15rd mags I have 4 G22 15rd mags for sale. I received theese as pre-bans but I'm not sure they are. 2 are LEO marked and dated 9/13/94 2 are plain and have the caliber markings just below the square cut out in the top of the mag. The 2 LEO mags have #5 followers and the other have #6. $20each plus shipping or, all 4 for...
Started 1 week, 1 day ago (2009-12-13 03:57:00)
by Glock_Holiday
G22 3rd gen. This was an LE trade in. Frame and barrel finish look near new. frame has some holster marks. Has an older set of meprolight night sights. Again this is a used gun but is in good condition. Comes with two LE high cap mags. $425 shipped to your FFL.
Started 1 week, 3 days ago (2009-12-11 16:41:00)
by mgs
I picked up a used LW .357Sig (extended or G35) barrel for use in my G22 a few months ago....works great but did I read somewhere here not to run it in a second generation G22 frame? I've just shot some UMC 125FP so far and I works great. I'm going to get some WW Ranger 125HP for it. The WW Ranger 155HP is very accurate in my G22 and my Beretta Carbine, Mike.
Started 1 week, 5 days ago (2009-12-08 19:28:00)
by Brendfan
I have the following Glock Factory Mags for sale: G22/24/35 5 15-round magazines for G22 (4 are new and unused, and 1 has had rounds loaded in it) These mags do not have the ambi-cut. Price: All five for $100 shipped via USPS Priority CONUS. G26 7 10-round magazines for G26 (6 are new and unused, and 1 has had rounds loaded in it). Price:...
Started 1 week, 6 days ago (2009-12-08 18:56:00)
by markerdown
G22 Recoil Spring Question So I'm learning about my glock 22. It does not have the stock recoil spring/guide rod unit that pops in/out as an assembly. This sucker is twice as long when removed and a freakin' bear to stuff back in!! Need 3 hands to hold the spring, the drive rod end and an end bushing to install. Was ...
Started 2 weeks, 2 days ago (2009-12-05 16:07:00)
by GlockSpeed31
Weekend Special $400 cash WTS Face to Face Only 3rd gen Glock G22 (full size) 40 S&W with finger grooves & tac rail Serial # begins with DGN w/ std sights and Uncle Mike's reversable clip belt holster with built-in mag pouch. Comes with (1) 15 rd mag & (1) 10 rd mag Has a slip on grip sleeve with small slit (1/3") in the back. Gun has some holster wear on slide as seen in ...
Started 5 days, 23 hours ago (2009-12-15 19:06:00)
by Huntabuck
I was just wondering if anyone has any experience they can lend me about this ammo. From the stats I have found it has more muzzle velocity and energy than 165 and 180 grain loads. I just don't know how well it expands, what kinda hole it leaves, etc. I looking into it as a defense round or a hunting round for deer. Thanks in advance for the advice
Started 4 days, 22 hours ago (2009-12-16 20:20:00)
by sgtlmj
As new. Not a single round fired through it. I've had it mounted a couple times, but never even dry fired except to remove it from the frame. Comes with 2 extra mags. I cut the foam in the lid to accommodate them. Don't think I did too bad of a job. I have so much junky 22LR ammo laying around that I just haven't bought any decent stuff to run through this. I'd be better ...
Started 5 days, 22 hours ago (2009-12-15 20:15:00)
by 207Copper
As stated above in great shape, just don't use it. Less than 400 rounds shot all PMC/Fed white box no reloads. New cost of barrel and TP shipped TMD was just under $140.00. I would Like to get $100.00 Shipped Conus. Insurance Extra. First I'll take it followed by PM gets it. Specs/Info: LWD Barrel M/22 Conversion to 9mm Extended and Threaded 1/2 x 28 LWD Barrel Link...
Started 1 week, 1 day ago (2009-12-13 13:12:00)
by QNman
Howdy! I am a gun enthusiast and am the proud owner of... ahem... "more than a couple" handguns. I have five Glock of various calibers and sizes, and have been a Glock fan since the 90's, when I bought a brand-new-to-market G22 in .40S&W. I recently got onto the xD bandwagon... I refrained from the standard xD's, I guess because they didn't appear to differ much from the Glock's I already ...
Started 1 day, 20 hours ago (2009-12-19 22:33:00)
by Anonymous
It was a very interesting time at Tornado Alley and I was like a kid in a candy store checking out the personal freedom machines... an awesome Lancair IVP from Arizona, several Cirrus G22, both new and old. Given that they had several Cirrus with the engine removed, I was struck by two things... how much red silicone caulking they had on the firewall, and how puny the engine mounts and support ...
Started 1 week ago (2009-12-13 22:06:00)
by 45DAVID1
Mine is a walther g22. I bought every available walther accessory for it when they first came out (the walther laser and walther red dot sight). I hate that stupid rifle but just cant seem to part with it.
Started 2 days ago (2009-12-19 18:01:00)
by GlockSpeed31
Buy both for $550 cash or interesting trade see bottom for trade ideas (no old stuff please) Face to Face Only 3rd gen Glock G22 (full size) 40 S&W with finger grooves & tac rail Serial # begins with DGN w/ std sights and Uncle Mike's reversable clip belt holster with built-in mag pouch. Comes with (1) 15 rd mag & (1) 10 rd mag Has a slip on grip sleeve with small slit (1/3") ...
Started 1 week, 1 day ago (2009-12-12 20:33:00)
by Amurr
Hello, Never had any interest in a glock before. They had nothing to offer me personally. Always respected them just never thought I had any appreciation for them. My buddy brought over a fresh spanking new G22 the other day and something broke inside of me. It was sleek, it was light, no external controls to snag. 15 rounds of 40S&W made me feel all warm and tingly inside. Glocks famous ...
Started 1 week, 1 day ago (2009-12-12 22:22:00)
by timbob
i grabbed one of these because i found one for well below retail price NIB, and after about 200 rounds on my g22 i'm far less than pleased with the results but not completely. i tried it out in a couple of different setups. first i zeroed it in at 25 yds using a gun vice. took 3-5 shots, adjusted to the center of the group and it was in fact zeroed in for subsequent hand-held fire....
