Thread: Rack Mounting a Non-Rackable Device

Hello Doctor > It really depends on some other details you > left out. Are you working with a two post rack > or four post, what type of shelf and just how > heavy is the device? The rack is four post, and I'm using a flat--no holes or openings in the surface--full shelf. I don't have an exact weight, but the device is not too heavy (it can be lifted and carried without any strain). > If however you...

Quote: Originally Posted by Neoeclectic I try not to use shelves as they tend to be more of a hinderance than a solution for my data center. I will always go for generic "L" brackets that can mount in just about any rack if I have them available. They don't take up a 3/4 to a full RU profile that shelves do and can support quite a bit of weight (up to 200lbs or so). Plus they're more aesthetically pleasing than a...

Why not put it on a shelf? Secure it with velcro or zip ties. If you need to block airflow through the cabinet, cut a hole in a 3U blanking panel for the device to poke through. Ken

Gritty, My recommendation would be to go purchase couple rubber tie down straps. You can typically pick them up at a local hardware store for a few dollars. You can then use the side of the shelf to secure the strap's hooks to. With the proper sized strap, you can get enough tension to keep that sucker in place. I would only run the straps over the top of the device going side to side (not front to back). The rubber on the strap will...

I try not to use shelves as they tend to be more of a hinderance than a solution for my data center. I will always go for generic "L" brackets that can mount in just about any rack if I have them available. They don't take up a 3/4 to a full RU profile that shelves do and can support quite a bit of weight (up to 200lbs or so). Plus they're more aesthetically pleasing than a shelf which is always a big plus for me.