Thread: Logitech Harmony One Discussion Thread - Part Three

Quote: Originally Posted by andrewf I guess I was looking at each of my activities as if they use the buttons I have either copied to my hard keys or set up on the display. So I thought if I have say switch on TV as part of the Watch SKY activity I assumed I had to have the button physically mapped to the remote. I take it that I dont? If so then I'll try switching to Method 2.... Hello again. You're absolutely right - you...

Quote: Originally Posted by rob99 I've just upgraded to a onkyo 607 from a 605 when i start an activity the amp wont come on when you push the help button it starts up no problem worked perfectly with the 605 any ideas ????? Hi mate. I had the same problem and can't remember how I sorted it now but will get back to you when I remember?? I know, as much use as a chocolate fireguard!!! I think logical knows....

Quote: Originally Posted by andrewf I have now done this. Fingers crossed I have chosen the right inputs as they are just called video1, 2 etc On mine "Video 4" was HDMI 1 which I found by trial and error. HDMI 2 is Video 5 - so I guess component and PC are something like Video 8 and Video 9 respectively.

Quote: Originally Posted by ithorne If you add your lights to (e.g.) your watch DVD activity you could then put the lights on, lights off (or lights toggle) button onto an additional buttons page in that activity. When you start that activity the default will be to turn the lights on. When you stop they will get turned off - except if the next activity also needs them on. You could use the setting to never turn the lights...

Quote: Originally Posted by Jon Weaver Can you change power settings per activity? I have some LED lights around my TV, but there are no "discrete" power codes for it (and for the people who have helped before, this is not an X10 question). I want to add a 'Lights' button to my "Watch Sky" activity.. So I need to add my "LED Lights Device" into the activity.. And then add a...

Quote: Originally Posted by logiciel Yes, I'm sure monksy has diagnosed this right, so all you have to do is go to Devices> TV> Adjust Inputs> Method 2 (which ought to be the default of the four) then edit the list of Input Names and on the next page assign to each one the correct Input Command. But what is this "input button on the device" - what is it for? Sounds like it may be a "switch...

I understand everything that you say, and i've made a lot of purchases in the same way as you. Newport really isn't that far ! The offer was there anyway. Cheers Kev

Quote: Originally Posted by deckingman Is there any way to get the "One" to perform a command when all you have is the hex codes? Specifically, my Yamaha RX-V3800 receiver has 6 memories of which 4 are available from the original remote and I have programmed these into my "One" by learning from the original. The other two memories are accessed by going through the setup menu which is a complicated process....

Just to say that the IR2BT wasn't knackered, the guy updated all existing units and new units were fixed before being sold. The IR2BT, if it has had the updated firmware, continues to work flawlessly.

Quote: Originally Posted by ithorne On mine "Video 4" was HDMI 1 which I found by trial and error. HDMI 2 is Video 5 - so I guess component and PC are something like Video 8 and Video 9 respectively. Cheers I'll go for that. I thought the ordering was a bit odd as there as there are four AV ports in the list first, however I've just looked at the back of the Tv online and it goes AV1 AV2 Comp HDMI1 HDMI2 PC then...