Thread: Logitech Harmony 1100 Discussion Thread - Part Two

OK PZ - Logitech usually respond to pressure.

Thanks for that logiciel, I'll give that a go and see how it goes.

I'm getting annoyed trying to get the Xbox to properly shutdown and power up! It seems to work 10% of the time... the other 90% of the time, I have to use "Help / power off" to fix it. So it obviously 'can' power it no problems... hmmmmmmmm :S

Quote: Originally Posted by logiciel An update to what? Are you saying this only happens when you set the Device to be controlled by the extender, not if it's direct on IR? Correct - well at least, it's a lot less slow when not using the extender. Eg if I press the volume up button 10 times in quick succession: using the extender, the icon continues to flash on the remote for some 5 seconds after I've finished; using the remote...

Quote: Originally Posted by SG-22 Well hopefully i am about to be another board member getting a free replacement upgrade to the 1100. I emailed them about the usual freezing and stuck volume and they replied with the following: Credit where credit is due they may have dropped the ball a bit with the 1000 but they have made up for it with the replacement program and excellent customer support. I agree - kudos to Logitech for excellent...

Great news once again Lonigtech is no1

Just got to say how much im loving this remote. Can’t believe how much better than the 1000 it is. For a start the 1100 is so much faster to update, before i was waiting a good minute for the 1000 to upload all the changes I’d made and then reboot, now it takes literally 30 seconds! Its not just the update times that are quicker, the response times between the remote screens are much improved with no sign of delays. Top Marks Logitech...

I got it nailed in the end. Set the delay long enough after the first few HDMI output cycles when it goes into "Please Wait" mode to then set it to the one I need for the TV. (HDMI 2 > HDMI All > DELAY > HDMI ALL > HDMI 1) Regarding the screen getting in the way going from projector to TV viewing, after much persuasion I got the Harmony to raw learn the screen up control (ignoring the 12v trigger)...

@Algoz: If you're having issues with your 1000, try a fully firmware overwrite update. In order to do that, start your remote up in 'safe mode' by removing the bettery, then holding the power button while you reinsert the battery and the screen says 'safe mode' or 'safe mode activated'. Then connect it via USB to your PC as normal, and perform a firmware update. This will ensure that all the firmware in the...

Quote: Originally Posted by Algoz I've had the same problem with the volume button and freezing issues for months now. I'm at my wits end with it. I've sent them email today asking what they can do for me (as my 1000 is out of warranty now :-( They should sort you out, i had a Z5500 speaker set which were out of warranty and they replaced them. They are about the best out there for that kind of thing, unheard of these days really.