Thread: Installing under floor heating

Back to top Alert Moderators

Yes you can, bring the cold tails and probe wires up to a box on the wall where you want the controller to be. The sparky will then need to run a feed (could be a spur from a nearby socket) to an FCU that serves the floor heating. The circuit will need to be RCD protected. The works will need notification to your LABC. (Any registered spark will do this as part of his works)...

Back to top Alert Moderators

Sounds good. I was thinking about an Ambient system but I'm open to recommendations. Steve

Back to top Alert Moderators

I usually install Devi or WarmUp. Never had a bad'un yet.. Except when a client drilled a hole in the bathroom floor to fit a door stop __________________ TTC When you get to the end of your rope, tie a knot and hang on. - F.D.R.

Back to top Alert Moderators

Back to top Alert Moderators

Thanks. I'll look into these.