Thread: Having trouble getting bolt out (removing seat zx6r)

thanks for all the replies. Will give it another shot this weekend.

get one of these sets, it will pay for itself. You can get a lot of leverage with a ratchet, and push down a lot if you still need help, swing by

These bikes are assembled with "zip" guns in the factory and can make removing some of the bolts pretty tough . A set of metric " T " handle allen keys can be your best friend for your bike . Most of these bolts have very low torque #'s so it is safer when you tighten to use the " T " handle set so you don't have this issue again . The ratchet set is good as well essentially you...

Quote: Originally Posted by mystifier bike: 08 zx6r..... hmmm. that's a pretty new bike, so not likely jammed and I think you just bought it this summer.... I hope you're turning counter clockwise.

Quote: Originally Posted by gav.man Run to the hardware store and buy a set of allen sockets. 3/8" drive. Spray a little wd40 on the bolt and let it sit for a few hours to soak in. They should be strong enough to put a bit of torque on them. I doubt its rusted or seized as its an 08 (unless its parked outdoors). Sometimes they are put on there fairly tight at the factory & need some extra oomph to remove. Keep the pressure...

Run to the hardware store and buy a set of allen sockets. 3/8" drive. Spray a little wd40 on the bolt and let it sit for a few hours to soak in. They should be strong enough to put a bit of torque on them.

Put some downward pressure on the seat. Should probably help a bit. But normally those bolts shouldn't be difficult to remove, unless it's your first time doing it. I remember all my bolts were TIGHT the first time round. U just need a good ratchet and hex set and give 'er.

use a ratchet on it. i had the same problem when i took mine off the first time. it was on pretty tight.

allen keys? Philips? i'm not familiar with the exact bolt, but i am familiar with removing stubborn bolts. if its an allen, go to the imperial allen sizes and find a slightly bigger size, bang it in, you should be able to twist it out. if Philips a good bit makes a huge difference. make sure u're using a no.2 bit (most screws are no.2) and hammer it in for greater contact and make sure u're trying to screw it out exacly along...