Do you have the stator in your hand or is it still installed in the bike.
Thread: 3 phase stator  |
|||||||||||||
|
Started 1 month ago by atoka1960
how do you test a three phase stator
|
|
||||||||||||
|
|||||||||||||
Other posts in this thread:
Hoople replied 1 month ago
Am I correct by saying your battery is not charging and your not sure if the problem is your stator or regulator? If Yes:
Stators are pretty rugged. What usually takes out a stator is a shorted regulator. (and of course a "loose rotor") There is a good chance if the stator is shorted, the primary oil will smell burnt. You can make some G0-No-Go tests with an ordinary ohm meter but they ...
Size: 666 bytes
Customize: 
atoka1960 replied 1 month ago
what i want to know is a three phase stator has three wires instead of two how do you connect to check stator output
Size: 180 bytes
Customize:
Hoople replied 1 month ago
You want to check the output of the stator directly without inserting a regulator and battery to make a complete charging system.? There is no real easy what to do that, that I know of. It could be done, but it would be involved. You would have to setup dummy loads on the outputs to do it.
But,... you could make some very basic tests using a meter.
Disconnect the 3 pin connector ...
Size: 1,297 bytes
Customize:
ron1978 replied 1 month ago
use ohm meter, check each wire and see if you have a major difference, if one is different you have a open stator, if all three look close, stator is good,
i work at a electric motor shop, this is how we do it.
its prob your regulator , i have replaced 2 on atv, and 1 on dads 85 fxstc.
Size: 373 bytes
Customize:
Hoople replied 1 month ago
Ron,
In your motor shop do you guys rewind armatures that have brush commutators or are you strictly induction motors.
Hoop!
Size: 226 bytes
Customize:
ron1978 replied 1 month ago
majority induction, every blue moon we get some dc work
Size: 119 bytes
Customize:
Hoople replied 1 month ago
That is fascinating work. There were so many times in my life I wish I knew someone that did that kind of work for a living. How long have you been doing it.
Size: 223 bytes
Customize:
ron1978 replied 1 month ago
10 years in may
i worked 5 years for lamb greys harbour, making recycling paper mill machines, from raw metal , to fully funtional, i loved it but job went to mexico, so i went into the motor shops field, i also do field balancing of single and duel plane fans, of and size.
Size: 356 bytes
Customize:
|
Top contributing authorsRelated threads on "Harley Davidson Community":Related threads on other sites: |
||||||||||||
Thread profile page for "3 phase stator" on http://www.hdtalking.com.
This report page is a snippet summary view from a single thread "3 phase stator", located on the Message Board at http://www.hdtalking.com.
This thread profile page shows the thread statistics for: Total Authors, Total Thread Posts, and Thread Activity
Home |
About Us |
Submit Your Site |
Update Your Site |
Get Search For Your Site |
Partners |
Contact |
Search Plugin |
Blog |
 |
Last Searches | Top Searches |
Designated brands and trademarks are property of their respective owners.
Use of this website constitutes acceptance of BoardReader's User Agreement and Privacy Policy.