Rear end clunking noise ( I know rear end) | Thread profile

OK guys, I drove the 4Runner yesterday with the 37's for the first time, boy is that thing tall..........to tall. Anyway I am driving it everywhere to break in the springs and hopefully get some sag in it. So here is the problem, when I accelerate rapidly or stop rapidly the rear end makes a clunking sound. Sort of like the third member is being pushed up or down and then setting in place....

Could be a worn out u-joint at the axle end of the driveshaft. Did you just lift this rig? Maybe it was worn before, but not too noticeable with the stock driveshaft angle, and now with a steeper angle it is causing the noise???

go check your u-bolts

U-Bolts Tight As You Can Get Them. Bad U-Joints 40$ At Toyota, And 18.99 For Liftime Warranty At Checker. Anti-Wrap Bar, Unless You Have A Anti Wrap Leaf Then You Dont Need One. Check You Pinion Nut To See If It Is Tight.

Aslo If You Have Anti Wrap Leaf Make Sure It Is On The Solid Point, Not The Shackle.

Thanks for all the info guys, most of you were right on the nose. Found the issue, seems that the U bolts came loose after driving only 20 miles. My friend torqued them to the correct specs and we planned on checking them again in about a 100 miles but now I think everyday for about a week and then once a week for a month or so.

It might be worthwhile to put some locktite on there after you get them tightened down.... Also, did you reuse the locknuts/lockwashers?

The bolts are staying tight, the U bolts are stretching a little at a time. I checked them again last night and they were dead on, same torque spec I set them to on Friday. Looks like they are done stretching. I will add some loctite once I feel everything is ready to go.