Dyno Fun!! | Thread profile

We are lucky enough to have a dyno on site, so curiosity got the better of us and we decided to test our cars today. Must admit I was a little nervous at signing a disclaimer form then watching the car being taken to its rev limiter in third but its all very controlled with temperature, emissions etc all monitored and logged. So after a decent warm up two runs were made, both ...

s dyno graph 993 _0001.jpg Description: Filesize: 232.09 KB Viewed: 146 Time(s)

Where did you have it done? Is this open to anyone? _________________ 996 C2 Cab - GT3 AeroKit

Hi Yes its a normal garage just happens to be on our site. They do work on some interesting cars, they had a Westfield and Ginetta G4 in the workshop. Web address is http://crazyhorsesracing.com/ They are in Borehamwood, Herts, the rolling road is mobile so they do club visits circuits etc. _________________ "Damn the torpedoes, full speed ahead!"

The rpms look a bit low, unless your car's limiter kicks in a 6200!

Yes it does look a bit low...the book says 6700 rev limit. Both cars did the same max rpm(I think!) I may ask them to check their machine...I'm not too bothered if it is set to 6200, the torque drops off past 5000 anyway so not much point going above that. _________________ "Damn the torpedoes, full speed ahead!"