changing Body Bushings | Thread profile

So my Energy Suspension Poly body bushings yesterday, and started on them this morning. First I had to take the nose apart as I removed the whole front clip together when I pulled the engine. Man there is a lot of bolts that hold the fenders to the nose . So then I put the header pannel and nose on the car with the new bushings, never marked where the old shims went that were under the old ...

take the rear bumper off also. take out the body bolts from one side, loosen only the other side, then jack up the side the bolts are removed from about 4 to 6 inches slowly and carefully, that will allow the room to change all on one side, you may notice rusty and enlaged holes in the frame, seems like a vender sells new sections to weld in or just lay on the frame. Watch the rear most ...

Luckly there isn't any rust on my frame and all holes are as they should be. Also I had the pass side all loostned up, and had the drivers side of the body about 7-8" off the frame and couldn't get my hands in to take the old bushings out, especially the bushings just infront of the lower control mounts. I may just use 2 jacks and lift the whole body evenly up off the frame. Are there ...