Parts | Forum profile

lifters sold

Quote: Originally Posted by 289Notch I just ordered one. and FYI. They take 30% off but there is a 10% insurance fee. and shipping to my door was $94 via truck. There is a 3-4 week build time on the hood I ordered. That is all. carry on. Im going to have to check it out.

here is what i made... not done yet

Quote: Originally Posted by UptonFord1989 Just buy Cervinis. Quality. dude, we have fox mustang racecars and we run 15 lb hoods. I have a cervinis on my cobra. $175 vs $400 or $500 makes the decision not as hard.

Quote: Originally Posted by RegalX The removable 3rd member of a 9'' is nice and as far as an increased power loss from a 12 bolt to a 9'' I am sure you would never notice any different unless your some dyno numbers faggot A 9 inch is about .05 to .10 slower in a 1/4 mile in a low 10 second car. I guess I am a dyno faggot for that statement.

Quote: Originally Posted by ds5dot You will have a hard time breaking a 12 bolt. You could do that 12 bolt cheaper than $1500. yea, i know but like i said i figure by the time i invest a bunch of cash into the 12 bolt, i could just sell it as is and spend a few more bucks on a 9" and most likely never have to worry about any rear end problems. i figure i can get a bolt in 9" housing for 500, center section with spool for...

Cervinis also weighs more than a stock steel hood

Quote: Originally Posted by tls90lx Cervinis also weighs more than a stock steel hood False. Neighbor has a 4 inch cowl and it weights considerable less then a stock hood.

Quote: Originally Posted by BigMatt I will semi-edit this have a trans looking for case fill deep pan and a servo kit. I know its a long shot but throwing it out there. Also a 157tooth flexplate in 50oz imballance damn you I need one of those as well

Quote: Originally Posted by OhMannClint damn you I need one of those as well They arent too spendy new but this is an extreme budget project