General Technical Forum | Forum profile

ops sorry i didnt think that would print just my spelling is bad _________________ regards steve you have only one life, enjoy.

i had this with my subaru forester after 3 sets discs i got it right - got 3rd set free but it was suggested i use a dial guage to make sure disc runout was within acceptable limit basically if the runout is wrong, the disc isnt perfectly alligned with the pads/calipers so as disc goes around it rubs at a high point on each side the the disc, and after a few 100-1000 miles this ...

Hi Any help please!!!!!!!!!! TLC colorado r reg.'98 rear light in bumper........can you purchase just the back bit (without the lens etc) looks like you can from the toyodiy site (will this be main dealer). MY DS one has rusted thro and l cant get a bulb to stay in and the wiring is Kaput l assume that these are screwed to the bumper (any tips on removal) and there is a plug to the ...

I've removed bushed by drilling through the rubber all the way round to remove the centre. The ones I did had a outet metal sleeve that I hacksawed out a small section then knocked it out. Worked wonders _________________ '98 Colorado GX 3.0TD - No mods, not even hovered...

Hi all, A question for all you mot testers out there. My dog has chewed one of the 3rd row seat belts - about halfway through and quite obvious. However I have removed the 2 rear seats anyway. Due for an mot in Dec. My question is, will the 3rd row belts be included in the test as they are not in use?? Should I remove them altogether? Or maybe I should just leave the dog in the car...

hi xjd, i used milner off road for mine and they are currently £23 plus p&p,google milner off road? some others on here might be able to tell you if there is anywhere which is better value. _________________ "ANGEE" it needs hoovered out again

Hi mate Me n Tommo went for the bravery option. 10mm hole in the centre of the roof at the rear, generous amount of silicon sealent, and all the cable neatly tucked away behind the headlining etc. The mount I use is the one that needs a wingnut and protrudes about 25mm when the twig is off. Tommo's is the screw in type but after a while it starts to twist as you replace or ...

Yep - how to make sure the ground anchor table is level. Or did you mean towing an off-road trailer through a desert? I'll get my coat....

I think there's a thread on it on PradoPoint.com somewhere - do a search? Do you think the reflectors / wiring / lens etc. will cope? That's one thing that's put me off - I'd rather replace the stock wiring loom so it puts proper power through and you get better light! Cheers

if i was'nt skint mate i would have them