|
More site info...
Engine Performance | Forum profile
|
|
Forum profile page for Engine Performance on http://www.fjcruiserforums.com.
This report page is the aggregated overview from a single forum: Engine Performance, located on the Message Board at http://www.fjcruiserforums.com.
This forum profile page summarizes the general forum statistics such as: Users Activity, Forum Activity, and Top Authors, which are reported in either a table or graph below for a given reporting time period.
Additional forum profile information for "Engine Performance" on the Message Board at http://www.fjcruiserforums.com is also shown in the following ways:
1) Latest Active Threads
2) Hot Threads for Last Week
Warning: These statistics are generated using 'best efforts' and can experience delays and reporting errors at times. Please note that such statistics do not constitute a forum's popularity and/or exact posting volumes at any given reporting period.
|
|
|
|
|
Posting activity on Engine Performance:
|
|
Week
|
Month
|
3 Months
|
|
Threads:
|
43
|
145
|
462
|
|
Post:
|
249
|
624
|
2,067
|
|
|
Engine Performance Posting activity graph:
|
Top authors during last week:
user's latest post:
Re: Engine suffocation
Published (2009-12-01 16:09:00)
Quote: jayman previously said: Well, sounds like problem solved! A question directed at both you and FJeddah: the FJ Cruiser sold in the Mid East still has the emisisons control intact? I haven't been to that part of the world since 2000, but I do recall back then, most vehicles intended for your market were shipped without emission controls FJCs' are sold with emission control, I guess most of the imported cars are now sold with...
user's latest post:
Engine suffocation - Page 3 -...
Published (2009-12-01 18:27:00)
Quote: FJeddah previously said: FJCs' are sold with emission control, I guess most of the imported cars are now sold with emission control. That's too bad. Things are much simpler if you don't have to worry about it Quote: FJeddah previously said: White grease? or any none conducting grease? For general use with dry o-rings, I've had good luck with silicone dielectric grease. There are special greases just meant for dry...
user's latest post:
Transmission Cooler? - Page 2 -...
Published (2009-11-30 18:35:00)
Yes, I have installed a Transmission Cooler before but I have never installed an oil cooler.
user's latest post:
Volant CAI Installed Today...
Published (2009-12-01 00:58:00)
Kind of weird that the made their snorkel only to work with their CAI. Hope they make converter kits to the TRD/AFE and to the stock intake. Sounds like they need to hire someone with a degree in marketing, haah.
user's latest post:
Volant CAI Installed Today... -...
Published (2009-12-01 22:21:00)
Quote: Steve G PW previously said: not having to touch the filter again for a good long time (100,000 miles... we'll see) Don't kid yourself about not touching the filter for 100K miles. You will have to clean it periodically and regularly. DEWFPO
user's latest post:
Changing Spark Plugs...help? -...
Published (2009-11-29 15:27:00)
Took me about an hour to do. Drivers side is by far the hardest but as long as you take your time everything will go smoothly. Some tips 1) Make sure you have VERY long extensions for all of your sockets. 2) take the support bar for the intake off of the drivers side in order to free up some space. 3)use the plastic spark plug distributor cap thing as a tool to remove the plug once its loosened. Dont be afraid to tackle this job your self....
user's latest post:
16 mpg highway?! - Page 6 -...
Published (2009-12-01 16:40:00)
FYI, on the way back I adjusted my cruise from 75ish to 65ish, and averaged a MPG of 19.3 up from 16.7. That flat windshield really does not like speeds over 70..
user's latest post:
16 mpg highway?! - Page 2 -...
Published (2009-11-28 16:21:00)
If you could find someone to trade with. But if ya go out and buy a new one, well that's a lot of gas money that would take awhile to pay for itself. I'd keep it myself.
user's latest post:
16 mpg highway?! - Page 6 -...
Published (2009-12-01 20:28:00)
That's also a diesel Sharp, they will get better fuel mileage. Build a diesel FJ and watch out!!
user's latest post:
Spec Aftermarket Clutch - Page 4...
Published (2009-11-24 08:18:00)
Quote: kualenamanao previously said: Ill be patient for now, but do you have forced induction for your FJ? TRD CAI only for engine mods. My truck is a bit heavier with the mods and all so maybe that was heat'n up the stock clutch quicker (35's and stuff) but all seems sorted now....
|
|
|
|
Latest active threads on Engine Performance::
Started 3 days, 1 hour ago (2009-11-30 20:05:00)
by Steve G PW
Pic 6] View showing the inside of the sealed filter box
Pic 7] View showing the filter box mounted. It sits at an interesting angle (tilts up slightly)... and it sure seams like the hood won't close... But, I assure you it closes just fine
Pic 8] Filter installed
Pic 9] All done!
Pic 10] Volant includes an extension for the vacuum line... But, Sam couldn't figure out why they just...
Started 5 days, 6 hours ago (2009-11-28 15:40:00)
by Hindsight
My highway mileage before mods was at best 17.
Doc
Started 5 days, 16 hours ago (2009-11-28 05:06:00)
by FJeddah
I hope I have used the right term to express my problem.
The same problem happened before 10 months or more, when I noticed a black smoke coming out the exhaust when I hit the gas when the car isn't moving. When I hit the gas while the RPM is 600-700RPM, the RPM goes below 500, it feels the engine is going to shut off, and then it goes back to normal. On ScangaugeII, the ignition appears in...
Started 1 week, 3 days ago (2009-11-23 05:47:00)
by BlackCherryota
There are transmission oil lines which run to and from the radiator. Both ports are on the driver side "tank" of the radiator. Whether or not this serves any "cooling" function is debatable. My previous vehicles' factory setup which had similar lines plumbed into the radiator did more harm than good, as the fluid was actually heated rather than cooled. This helps transmission function in the ...
Started 1 week, 2 days ago (2009-11-24 12:02:00)
by FJC8871
Oh nice. Bump for some lucky 2010 owner.
Started 1 week ago (2009-11-25 22:37:00)
by JAXTOY
No, it is a friction fit. You are not missing a bolt.
Started 3 months, 1 week ago (2009-08-25 07:32:00)
by VT_RainMan
No crap... i was going to take pics of this tonight and post it up. Same thing here... have to buy new couplers. !@#$! I'm a little more than pissed about that. Never seen silicone do that before.
Started 1 year, 8 months ago (2008-03-30 06:17:00)
by stringmachine
hey bud, if you remove the big black cover on top of engine you will see 3 black covers on one side and 3 on the other they all have a bolt holding them in. under these are the sparkplugs. remove bolt then pull off boot. the passenger side is a breeze to get to and the driverside fron is easy. for the back 2 you will need to remove the black bracket that is in your way, i just loosened mine and...
Started 2 years, 7 months ago (2007-04-27 21:02:00)
by TCao
Jeff:
Is the price for the SPEC clutch comparable to the factory one?
Started 1 year, 8 months ago (2008-03-25 09:54:00)
by gunner5355
http://www.airaid.com/510-201_toyota.asp
air intake p/n # 510-210
oe replacement p/n # 700-458
on line dealers
http://www.airaid.com/dealers_online.asp
good luck with East Europe, hope you fine one.
|
|
Hot threads for last week on Engine Performance::
Started 5 days, 6 hours ago (2009-11-28 15:40:00)
by Hindsight
My highway mileage before mods was at best 17.
Doc
Started 5 days, 16 hours ago (2009-11-28 05:06:00)
by FJeddah
I hope I have used the right term to express my problem.
The same problem happened before 10 months or more, when I noticed a black smoke coming out the exhaust when I hit the gas when the car isn't moving. When I hit the gas while the RPM is 600-700RPM, the RPM goes below 500, it feels the engine is going to shut off, and then it goes back to normal. On ScangaugeII, the ignition appears in...
Started 1 week ago (2009-11-25 22:37:00)
by JAXTOY
No, it is a friction fit. You are not missing a bolt.
Started 3 days, 1 hour ago (2009-11-30 20:05:00)
by Steve G PW
Pic 6] View showing the inside of the sealed filter box
Pic 7] View showing the filter box mounted. It sits at an interesting angle (tilts up slightly)... and it sure seams like the hood won't close... But, I assure you it closes just fine
Pic 8] Filter installed
Pic 9] All done!
Pic 10] Volant includes an extension for the vacuum line... But, Sam couldn't figure out why they just...
Started 1 year, 8 months ago (2008-03-30 06:17:00)
by stringmachine
hey bud, if you remove the big black cover on top of engine you will see 3 black covers on one side and 3 on the other they all have a bolt holding them in. under these are the sparkplugs. remove bolt then pull off boot. the passenger side is a breeze to get to and the driverside fron is easy. for the back 2 you will need to remove the black bracket that is in your way, i just loosened mine and...
Started 1 week, 3 days ago (2009-11-23 05:47:00)
by BlackCherryota
There are transmission oil lines which run to and from the radiator. Both ports are on the driver side "tank" of the radiator. Whether or not this serves any "cooling" function is debatable. My previous vehicles' factory setup which had similar lines plumbed into the radiator did more harm than good, as the fluid was actually heated rather than cooled. This helps transmission function in the ...
Started 1 year, 8 months ago (2008-03-25 09:54:00)
by gunner5355
http://www.airaid.com/510-201_toyota.asp
air intake p/n # 510-210
oe replacement p/n # 700-458
on line dealers
http://www.airaid.com/dealers_online.asp
good luck with East Europe, hope you fine one.
Started 3 months, 1 week ago (2009-08-25 07:32:00)
by VT_RainMan
No crap... i was going to take pics of this tonight and post it up. Same thing here... have to buy new couplers. !@#$! I'm a little more than pissed about that. Never seen silicone do that before.
Started 1 week, 2 days ago (2009-11-24 12:02:00)
by FJC8871
Oh nice. Bump for some lucky 2010 owner.
Started 3 weeks, 6 days ago (2009-11-06 15:39:00)
by porterroad
Getting more horsepower advice
I have a '07 with about 58k miles. Already put in a TRD intake and exhaust. Whats the best next step to get some giddy-up outta my FJ? I'm looking for some ideas for mods under $1000 so i can get the funds cleared from my wife
|
|
Size: 1,298 bytes
