Items Wanted | Forum profile

I think I've still got the yoke and the shaft in separate pieces, but maybe not the rear piece. I'll post back up this afternoon.

still got one,,im sure i posted before i must be too expensive but my price stands 200 plus shipping,,,ive shipped trannies before not a problem

The shaft is held together by a couple of snaprings, easy to dissasemble. Make sure you mark it with a paint pen or scratch awl so the bearings go back in the same bores they came out of. Also get the tool to tighten those metal bands used to secure the boots. It can be done with other tools but way easier to get it tight with the proper tool.

I have a red grille and the driver side headlight motor

sunroof no sunroof?

PM'ed. I have 2 stock 12a turbos for sale.

bought some oem ones from dad they will work fine for now i hope

Lummy, on 06 November 2009 - 03:55 PM, said: Ok, I'm chasing a few parts for my Starion... Outer tie rod ends (2) Inner tie rod ends (left and right) Tie rod sleeve Lower ball joints (2) If someone has a good supply of these parts for a good price, I may be interested in buying more than 1 set. Shipping would be to Australia. Thanks. Rock Auto Look here they will ...

i have them.

My Quest has vibration under acceleration (a rumble) off the line. Found several bushing have play but, I suspect that the rear trans mount and the upper and lower cushion where the front of the differential mounts to the front support may be weak. There seems to be alot of play, though the rubber cushions still seem to be intact. I am able to raise and lower as much as a half an inch with a ...

i might have an 88 rolling upnorth. heading up there this weekend will let you know, dono if my dad got rid of it or what. everything is there but the engine and trans. we have the trans separate but not in the body right now. if its still up there asking 500. located in michigan

still got one,,im sure i posted before i must be too expensive but my price stands 200 plus shipping,,,ive shipped trannies before not a problem

I think I've still got the yoke and the shaft in separate pieces, but maybe not the rear piece. I'll post back up this afternoon.

The harness you need, is that the one on the right hand side of the car? I can't remember which one has which plugs anymore. I only have the half of the harness that goes to the ECU.

Taken Care of...Thanks for all the help. Nathan This post has been edited by nsstarion : Yesterday, 08:38 PM

boostdquest89, on 05 November 2009 - 02:23 AM, said: Hey guys, I am looking for (1) rear 9 inch rim. Tire guys said one of mine has a bend in it! I know its gonna be hard to find somebody to separate a set but if you have one lying around LMK. Thanks, Chad-

bought some oem ones from dad they will work fine for now i hope

TheVWguy, on 28 October 2009 - 01:27 PM, said: headlights go up, and wont go back down. looking for a switch for my 87 quest. Note that the headlite switch can be taken apart and their contacts cleaned.. Very EZ.. Just my $0.015...

sunroof no sunroof?