Exterior / Paint | Forum profile

dont spray paint the window!!! i have no idea about the pre-cut tint, but a buddy of mine used spray tint on his mustang rear window, looks perfect from the outside but when you look from the inside it looks absolutely horrible. Easiest thing in my opinion would be pull windows out and do it that way so you have a nice open area to work with the window. Its not that bad of a job if you clean the...

wait until you can get them painted

Yeah, it should. Im trying to figure out if a drivers side door off of a S-10 with a ex cab with the 3rd door will fit on a reg cab.

bump.... Come on guys, any help would be appreciated

do xenon prejectors, preferably quad bi-xenon projectors, that would be BAD ASS! other than that, Ive got no good suggestions...

you can sand it flat and reclear it and should not have an issue unless you used colored flakes... the reason for this is that colored flakes are just coated(ie the entire flake is not that color) if you sand through the coating of the flake then you will be exposing silver and depending on the effect you want...it can look kinda cool or it can ruin your day.

Zero rust is a POR 15 like product. Not somthing I'd recommend using out the outside surface of a vehicle.

Find a local junk yard for the cheap route. If you want after market try stylinconcepts.com or godfathercustoms.com

i dont have any experience with them, but they look pretty damn cool

um i think you will find that probaly all of us goes to junkyards to get parts atleast 75% of my truck has been built with junkyard parts. to many to list lol

Looks good! Should look real good put back together.

dont spray paint the window!!! i have no idea about the pre-cut tint, but a buddy of mine used spray tint on his mustang rear window, looks perfect from the outside but when you look from the inside it looks absolutely horrible. Easiest thing in my opinion would be pull windows out and do it that way so you have a nice open area to work with the window. Its not that bad of a job if you clean the...

yes fusion will work. no you dont need the adhesion promoter yes it will crack and peel but it will hold its o for a while. i have used it on alot of plastic stuff and never had any problems but it was not on a 4 wheeler. it will wear off regardless of what you use just from friction well riding. but for 20 bucks you cant beat it

do xenon prejectors, preferably quad bi-xenon projectors, that would be BAD ASS! other than that, Ive got no good suggestions...

yep, 98+ sonoma will swap to 98+s10 with just a bumper, grille and headlights but before you hate on the sonoma fronts, take a look at the envoy front clips, i personally think that the sonoma front ends have more pontential to have a cleaner look than an s10 front

My truck is actually an S-10 but I have a Sonoma Bumper and Headlights and a Bravada Grill. I think it looks good especially with the s10 hood where the center body line continues from the hood through the grill and into the bumper. The nice thing about this mod is it was very cheap (a little more $$$ for me since I had to buy a bumper and headlights too) and easy. You should be able...

my base and clear guns cost 5-600.....each watch ebay for sata .... http://motors.shop.ebay.com/Automoti...Condition=U sed

No such thing as a smoothie chrome bumper from GM. The chrome bumpers all had holes for the rubber bumper trim on the LS and LT models. I don't know how many different brands are out there for aftermarket. I'm looking to get one for my Blazer in the spring. I looked around on ebay and found one for about $120 shipped. I don't know if it's the same as the $250 ones on there or not.