|
More site info...
Overclocking and Cooling | Forum profile
|
|
Forum profile page for Overclocking and Cooling on http://overclockersclub.com.
This report page is the aggregated overview from a single forum: Overclocking and Cooling, located on the Message Board at http://overclockersclub.com.
This forum profile page summarizes the general forum statistics such as: Users Activity, Forum Activity, and Top Authors, which are reported in either a table or graph below for a given reporting time period.
Additional forum profile information for "Overclocking and Cooling" on the Message Board at http://overclockersclub.com is also shown in the following ways:
1) Latest Active Threads
2) Hot Threads for Last Week
Warning: These statistics are generated using 'best efforts' and can experience delays and reporting errors at times. Please note that such statistics do not constitute a forum's popularity and/or exact posting volumes at any given reporting period.
|
|
|
|
|
Posting activity on Overclocking and Cooling:
|
|
Week
|
Month
|
3 Months
|
|
Threads:
|
67
|
274
|
696
|
|
Post:
|
223
|
1,157
|
2,979
|
|
|
Overclocking and Cooling Posting activity graph:
|
Top authors during last week:
user's latest post:
New Watercooling Set-up on the...
Published (2009-12-02 07:16:00)
ill be running a similar setup, but now i am only doing my cpu. my next loop will be when doing my 2x 4870x2. at first ill put my rad on the back.
user's latest post:
Too hot for a Scythe Mugen 2?
Published (2009-11-28 09:15:00)
Nvm, I adjusted some stuff and now my temps max out at around 72 degrees on hottest core, at 4011Mhz and 1.23750v. Does this sound about right to you guys?
user's latest post:
Water Cooling
Published (2009-11-29 07:49:00)
QUOTE (guyrichi247 @ Nov 29 2009, 09:59 AM) If you want some serious cooling for your rad's then get a few of these babies actually that would do not much more than a 3000rpm
user's latest post:
Socket 1156/1366 Oc Competition...
Published (2009-11-25 12:31:00)
Been playing around again. New Pi run and Sui shot Look at the temps It will go past 4.7 but will BSOD half way in Pi no matter what i do. O this is running on 40% ethanol glycol between 5 and 9 oC This post has been edited by Danny_75 : Today, 05:44 AM
user's latest post:
Official Socket AM2 / AM2+ / AM3...
Published (2009-12-02 18:38:00)
Good score, but you know the TWKR is made to perform under extreme cooling, not under a poor Xigmatek!! I'm waiting for some ferocious competition there Although a competition on air is welcome too. I already have to get back my position, as I got beaten by two guys at SuperPI 1M... hehe... My next goal is to be under 16s on air.
user's latest post:
Stability
Published (2009-12-01 13:19:00)
One of the stick seems to be unable to get to the rated settings which is a bit of a bummer. Thankfully i have until thursday to return them within the 28day refund time Im gonna get some different sticks as i can get better RAM now for the same price I got these...anyone suggest any? Budget of £200
user's latest post:
Water Cooling
Published (2009-11-28 17:44:00)
If you really don't care about noise get a Black Ice Xtreme 360 with 6 3000RPM Scythe UltraKaze fans. But that's gonna sound like a damn vacuum cleaner.
user's latest post:
Stability
Published (2009-12-02 11:51:00)
Yep, that is a bad arse kit of RAM right there.
user's latest post:
CPU cooler suggestions please
Published (2009-11-28 03:40:00)
slick2500, that's one sweet cooler. I'm going with that one. Thanks.
user's latest post:
Official Socket AM2 / AM2+ / AM3...
Published (2009-12-02 22:20:00)
QUOTE (The Smith @ Dec 2 2009, 08:38 PM) Good score, but you know the TWKR is made to perform under extreme cooling, not under a poor Xigmatek!! I'm waiting for some ferocious competition there Although a competition on air is welcome too. I already have to get back my position, as I got beaten by two guys at SuperPI 1M... hehe... My next goal is to be under 16s on air. I was just getting windows...
|
|
|
|
Latest active threads on Overclocking and Cooling::
Started 21 hours, 59 minutes ago (2009-12-03 14:53:00)
by airman
On single threaded apps? It depends on the processors in comparison. If someone managed to get say, get an earlier generation Intel or AMD processor (like Pentium D or comparable AMD processor) to those higher clock speeds versus a dual core E8400 or something (at the lower speed), the E8400 would outperform the earlier generation CPUs by far. This is because of the architecture (...
Started 1 day, 19 hours ago (2009-12-02 17:12:00)
by Zertz
The Corsair H50 isn't that good. Prolimatech Megahalem, Thermalright TRUE and Noctua NH-U12P are pretty much the top 3 heatsinks available
Started 2 days, 3 hours ago (2009-12-02 09:36:00)
by kitfit1
Your problem is that you are trying to run 2 different types of ram together. They will both have different SPD's, even though both are rated at 1066. On the vast majority of mobo's, mixing different makes of ram just will not work. There are 2 ways out of this problem. 1: You could flash both sets of ram with the same SPD. 2: Buy another set that matches one of the sets you ...
Started 4 months, 1 week ago (2009-07-30 04:02:00)
by damian
Old screen shot, still saving up for a new motherboard. Suicide: AMD Phenom II X2 550W ASRock 780g G.Skill DDR2 800 2x1Gb
This post has been edited by damian : Yesterday, 04:06 AM
Attached thumbnail(s)
//
Started 4 days, 8 hours ago (2009-11-30 04:40:00)
by xchrissypoox
see if increasing the vcore helps alleviate that it. what about blend what happens when you run blend? have you tested your ram?
Started 1 year, 4 months ago (2008-07-08 13:47:00)
by hardnrg
I have since sold ALL these CPUs, bar the X2 3800+... I can't re-run these since these are all very old and from the original 939 competition thread if you can't add these because of the requirements, oh well... this is what I got with my beloved DFI NF4 Ultra-D Air setup (*sigh* good times) --- X2 3800+ Toledo 512k (No IHS) LCB9E 0719RPMW Air, Thermalright Ultra 120 ...
Started 3 days, 16 hours ago (2009-11-30 20:50:00)
by insan3
How to Watercool: http://forums.anandtech.com/showthread.php?t=4596 Very basic diagram of how to set up a loop, not the only way obviously: http://extreme.outervision.com/flowdesigner.jsp posted by chrissypoo on my water cooling thread pg 2
Started 3 years ago (2006-11-27 14:21:00)
by road-runner
I have to get a Conroe
This post has been edited by road-runner : Feb 22 2007, 11:22 AM
--------------------
Main Rig: Sonata Case, Antec 500 PSU, GA965P-DQ6, E6600/TT Typhoon, 402x9, 3.62ghz Stable 2Gb OCZ PC-6400 Platinum Revision 2, 4-4-4-15, W.D. Raptor 74gb, Maxtor Sata 120, Ati All in Wonder 2006
Started 1 week, 4 days ago (2009-11-23 10:02:00)
by Flibo
55c at full load is freezing Are you confident that you really need water cooling?
|
|
Hot threads for last week on Overclocking and Cooling::
Started 1 week, 4 days ago (2009-11-23 10:02:00)
by Flibo
55c at full load is freezing Are you confident that you really need water cooling?
Started 1 week, 1 day ago (2009-11-26 06:55:00)
by insan3
cooler master v8 on sale on newegg for $41 free shipping. on sale until Sunday because of the black Friday discounts.( newegg.ca and CDN price )
This post has been edited by insan3 : Today, 06:57 AM
Started 2 days, 3 hours ago (2009-12-02 09:36:00)
by kitfit1
Your problem is that you are trying to run 2 different types of ram together. They will both have different SPD's, even though both are rated at 1066. On the vast majority of mobo's, mixing different makes of ram just will not work. There are 2 ways out of this problem. 1: You could flash both sets of ram with the same SPD. 2: Buy another set that matches one of the sets you ...
Started 1 day, 19 hours ago (2009-12-02 17:12:00)
by Zertz
The Corsair H50 isn't that good. Prolimatech Megahalem, Thermalright TRUE and Noctua NH-U12P are pretty much the top 3 heatsinks available
Started 5 days, 18 hours ago (2009-11-28 17:58:00)
by The Smith
Woah! It looks soo awesome! I was never able to overclock the Athlon Neo MV-40 in my Dv2. I am downclocking and undervolting it instead, using RMClock. I gained 1h battery life to reach almost 6h. How much do you get from yours?
Started 21 hours, 59 minutes ago (2009-12-03 14:53:00)
by airman
On single threaded apps? It depends on the processors in comparison. If someone managed to get say, get an earlier generation Intel or AMD processor (like Pentium D or comparable AMD processor) to those higher clock speeds versus a dual core E8400 or something (at the lower speed), the E8400 would outperform the earlier generation CPUs by far. This is because of the architecture (...
Started 6 days, 8 hours ago (2009-11-28 04:30:00)
by N.E.A
thermal paste is not going to do a great change , maybe 0-3 temps will drop , if you are worried , and freaking out , i think a better cooler : prolimatech megahalmes..one of our memebers here got his 920 to 4.3 stable with nice temps ..
Started 5 days, 15 hours ago (2009-11-28 21:31:00)
by CowKing
i'd say those temps are fantastic for what you got. just make sure it's stable
Started 1 week, 1 day ago (2009-11-26 04:17:00)
by Timmy94
The Noctua NH-U12P is fairly good for the price and rivals the Ultra 120 extreme.
--------------------
If It Wont Boot, Clock It Higher Asus GTX 295 Acer 24" + Acer 19" Coolermaster CM 690 Gigabyte GA-P55-UD3P 4GB Patriot DDR3 1600Mhz Intel Core i7 860 @ 2.94Ghz Great Wall 700W + TT 450W VGA
Started 4 months, 1 week ago (2009-07-30 04:02:00)
by damian
Old screen shot, still saving up for a new motherboard. Suicide: AMD Phenom II X2 550W ASRock 780g G.Skill DDR2 800 2x1Gb
This post has been edited by damian : Yesterday, 04:06 AM
Attached thumbnail(s)
//
|
|
Size: 614 bytes
