Started 1 month, 1 week ago (2010-01-01 14:47:00)
by superswamper
YouTube - 05 Dodge playing in the snow2
Started 1 week, 5 days ago (2010-01-28 18:21:00)
by 96ram2500
Any dodge experts here? I have a 96
dodge ram 2500 with the cummins diesel. Fun truck, I bought it from the police in Texas. It had been a drug runner. Long story but it had been used on both sides of the law. Ran hard but by the time I got it had tons of new parts and is generally a good truck.
Here is my issue. The vacuum actuator that slides the right axle together to activate 4wd is bent...
Started 1 month ago (2010-01-08 19:32:00)
by 85swampmonster
has anybody ran an nv3500 in a full size pick up or know what they are rated for because
im lookin for a tranny for my project and i really want an nv4500 but there ridiculuosly expensive and the 3500 is way cheaper so iwqas wondering if anybody had any imput in this situation
thanks
Started 1 month ago (2010-01-04 19:13:00)
by superswamper
Now that is an old post(2003)...
Started 3 months, 3 weeks ago (2009-10-17 16:21:00)
by GoldToyBox
1000
miles from home and got a whole in the oil cooler line.
Got the line repaired and need to know which type of auto tranny fluid to use
dip stick says Mopar 4
This town only has one gas station, very small sellection
Dexron -III ok ??
HELP!!!!!!! gotta get back on the road!!!
Started 1 month, 3 weeks ago (2009-12-17 01:10:00)
by wsmm
My engine has been running low to zero
oil pressure for some time now. It's believe to be caused by worn cam bearings. This vehicle is just used to plow my and my brother in-laws drive. Is there any where, other than where the oil sending unit is, to tap in and get a pressurised oil supply that I cold route up to the rocker arms through the valve covers? We have used a mechanical test gauge ...
Started 2 months ago (2009-12-11 23:29:00)
by wsmm
I have a Holley 4 barel on my 79DodgeRamcharger ith 318 and automatic trnasmission. This vehicleis used on my property for snow plowing only. I have a stumble right off of idle that I can't seem to get rid of. Also as I got near the end of my plowing this time I encountered a kocking noise. Thoguht at first it was a rod knock. Headed right to the
pole barn to get it in. Shut it donw checked...
Started 2 months, 2 weeks ago (2009-11-25 16:34:00)
by sexman
I've been helping this guy put new intake gaskets and
timing chain in his truck. We also did the cap,rotor,plugs, and wires. Well, it runs but has no power and is alittle shakey at idle. We went over evrything on the ignition and checked the that the chain was put on right a few times. The only thing I can think of is a bent valve as the chain had jumped 4 teeth. What about bad injectors? ...
Size: 114 bytes
