|
More site info...
Pathfinder Forum / QX4 Forum | Forum profile
|
|
Forum profile page for Pathfinder Forum / QX4 Forum on http://www.nicoclub.com.
This report page is the aggregated overview from a single forum: Pathfinder Forum / QX4 Forum, located on the Message Board at http://www.nicoclub.com.
This forum profile page summarizes the general forum statistics such as: Users Activity, Forum Activity, and Top Authors, which are reported in either a table or graph below for a given reporting time period.
Additional forum profile information for "Pathfinder Forum / QX4 Forum" on the Message Board at http://www.nicoclub.com is also shown in the following ways:
1) Latest Active Threads
2) Hot Threads for Last Week
Warning: These statistics are generated using 'best efforts' and can experience delays and reporting errors at times. Please note that such statistics do not constitute a forum's popularity and/or exact posting volumes at any given reporting period.
|
|
|
|
|
Posting activity on Pathfinder Forum / QX4 Forum:
|
|
Week
|
Month
|
3 Months
|
|
Threads:
|
96
|
454
|
1,437
|
|
Post:
|
228
|
1,210
|
4,497
|
|
|
Pathfinder Forum / QX4 Forum Posting activity graph:
|
Top authors during last week:
user's latest post:
need good speakers
Published (2009-11-26 09:36:00)
personally when it comes to interior speaker i wouldnt get anything else than boston acoustics, when i get the money im getting boston pros for my fronts, 500$ a set,pricy i know but there sound quality is amazing. they use neodymium magnetswhich are extremely light weight but up to 3 times stringer than convention magnets, and their cross-overs use all gold plated compnenets. and they actually run about 650 a set, im getting a deal from the...
user's latest post:
When does the license plate...
Published (2009-11-26 01:20:00)
Quote, originally posted by JonathanPrem » When does the license plate light go on? When it starts to hurt. Billy
user's latest post:
Where do you buy your parts from?
Published (2009-11-27 20:06:00)
If it's an expensive part (over $100): CourtesyParts.com If it's not an expensive part (under $100): Local Nissan dealer Everything's cheaper in Texas; it's a fact.
user's latest post:
P0140 O2 Sensor Circuit No...
Published (2009-11-27 19:35:00)
What happened the next time you fired it up cold? After a long battery disconnect, the ECU forgets the fine tuning for your engine and has to relearn it.
user's latest post:
HID kit vs. Bulbs & color...
Published (2009-11-24 12:08:00)
well i have the 3500k hid in my fog lights and i just ordered some of the 6000k bixenons for my headlights, and ill prob order some 4300k for my offroad lights. i should be able to light up the world with all of that. now if only i can get my fog lights to work with the running lights
user's latest post:
Torque Converter Advice
Published (2009-11-24 19:02:00)
korbeanu, yeah that sounds like the torque converter locking and unlocking. drive up that hill with O/D off (the little button on the shifter) because then the torque converter will stay locked, see if that makes any difference you can even play with that button, turning od on and off, and you will then know if its the torque converter or not...
user's latest post:
Engine light will NOT go out on...
Published (2009-11-27 07:23:00)
angel, when you go back for another diagnostics, be sure to bring lube for your ***hole.
user's latest post:
P0300 Random/Multiple Cylinder...
Published (2009-11-27 16:33:00)
Well my Pathfinder has been running like absolute crap upon startup for the last week, sounded like it was bogging/misfiring, well today it finally threw a code P0300 Random/Multiple Cylinder Misfire Detected Once the car warms up it runs alot better, smooth anyways and not all choppy like on startup, but my idle seems screwed up aswell, if your at a stoplight sometimes the rpms drop to low and the car stalls. This all started after I...
user's latest post:
2001 QX4 HID headlights turn off...
Published (2009-11-23 20:29:00)
I do leave the lights on auto so that may be part of the problem,are you saying it doesn't happen if you turn the switch to the on position? Thanks!!
|
|
|
|
Latest active threads on Pathfinder Forum / QX4 Forum::
Started 4 months, 3 weeks ago (2009-07-07 09:37:00)
by JonathanPrem
Do you think you can making Lowering kit for R50
Started 1 day ago (2009-11-28 00:47:00)
by sicwitit
to attach a pic, first you need to host it somewhere, image shack, photobucket, or what ever. then, once its hosted, you need to cut and paste the url in between this and it will pop up in the threads the way you want it. if you need help, email me, it gets addicting once you learn how.
Started 1 day, 6 hours ago (2009-11-27 19:32:00)
by rlp
I was wandering the same as to who are the best vendors???
Started 2 days, 15 hours ago (2009-11-26 10:08:00)
by longhornsqx4
Well the car is defientely running like HORRIBLE, so something is wrong Thats the only code it threw though
Started 1 day, 8 hours ago (2009-11-27 17:33:00)
by Fieldy211
Upon further searching (and replacing the word shake/ shimmy with "sway") it seems like the dreaded "death sway". Will do the test now to confirm Any other place i can buy the lower trailing arms from the internet? Or must i go to the dealer?
Started 1 week, 2 days ago (2009-11-19 22:12:00)
by 2 Coupes
Oh man the A-10 is so amazing by far my favorite aircraft. TANK KILLER!!!!! To bad there is no display of my second fav the SR-71 Black Bird. Good pics
Started 2 days, 10 hours ago (2009-11-26 15:21:00)
by Chuck Tribolet
What are the exact codes? Google them here. NisTech wrote a nice write up of the Intake Valve Timing Problems. I've had them off and on for about three years. The truck still runs good, and I've learned that keeping the revs above 2500, esp' on hills, keeps the light out. Also, think about going to a heavier oil (10W-40 instead of 5W-30). The solenoids use oil pressure for power, and as ...
Started 1 week, 2 days ago (2009-11-19 21:43:00)
by fastpathy35
was the fluid labeled for matic d nissan? castrol import atf works also. i just bought the stuff to do mine. like seriously 10 mins ago..i would like to know if theres a problem with certain fluids before i do it. i bought valvoline dex/merc or something. it said for use with all infinitis and nissans. planning on doing my transfer case and all in the morning
|
|
Hot threads for last week on Pathfinder Forum / QX4 Forum::
Started 6 days, 7 hours ago (2009-11-22 18:42:00)
by fastpathy35
yeah you will lose your high beans like that. A lot of people who go that route either doesn't use their high beams often or don't care about functionality. Just looks. If you want to go cheap there are kits that move the beam in your headlight housings to aim the beam higher.
Started 1 week, 2 days ago (2009-11-19 21:43:00)
by fastpathy35
was the fluid labeled for matic d nissan? castrol import atf works also. i just bought the stuff to do mine. like seriously 10 mins ago..i would like to know if theres a problem with certain fluids before i do it. i bought valvoline dex/merc or something. it said for use with all infinitis and nissans. planning on doing my transfer case and all in the morning
Started 2 days, 15 hours ago (2009-11-26 10:08:00)
by longhornsqx4
Well the car is defientely running like HORRIBLE, so something is wrong Thats the only code it threw though
Started 4 months, 1 week ago (2009-07-20 22:08:00)
by WPGQX4
Started 6 days, 12 hours ago (2009-11-22 12:48:00)
by JonathanPrem
Welcome to the forum! When i got my H4's installed i had the same problem. It's cause that we have a daylight running light system , that wont lets us have the hids for daylight/high beam. I got my professional done so i have now clue about wiring. My headlights don't work during the day instead my fogs are on and my hids work when i turn it on and i have no high beams
Started 4 days, 9 hours ago (2009-11-24 15:56:00)
by fueler
junkyard transmission $1500 installed whether or not its worth it.... is up to you If it was a stock QX4, i'd consider selling it. But in my case, i have dumped so much money into my Q (all urethane suspension bushings, new timing belt, water pump, pro-comp wheels with brand new BFG tires, brembo brakes, old man emu lift, complete sound system, etc etc the list goes on) that it ...
Started 2 days, 10 hours ago (2009-11-26 15:21:00)
by Chuck Tribolet
What are the exact codes? Google them here. NisTech wrote a nice write up of the Intake Valve Timing Problems. I've had them off and on for about three years. The truck still runs good, and I've learned that keeping the revs above 2500, esp' on hills, keeps the light out. Also, think about going to a heavier oil (10W-40 instead of 5W-30). The solenoids use oil pressure for power, and as ...
Started 1 week ago (2009-11-21 05:57:00)
by alexf20c
LEDs do NOT pull more current than a halogen bulb. whomever said that is an idiot. anyway, it's common to blow fuses when you're working electrical, because as you disconnect/reconnect components you create arc shorts which can burn a low-amp fuse. in situations like this, always check your fuses. and for the record, i've replaced my interior lamps with LEDs and it's possibly the most practical...
Started 5 days, 17 hours ago (2009-11-23 07:47:00)
by Empty V
Quote, originally posted by t_b0ne3 ยป I have an 01' QX4 and when it gets below 45 degrees and the engine is cold the headlights will go out when I use the turn signals? When the blinker arm resets coming out of a turn it shuts the one on the side I turned to out or sometimes both? If anyone knows of a way to avoid this or fix it I would appreciate it! Sounds like the switch on the ...
Started 5 days, 16 hours ago (2009-11-23 08:57:00)
by Natedogg1701
well i got the first 2 codes from this forum, one of the first 5 posts thats stuck in place has an obd2 code chart. heres the 2 i cud find for ya. P0135 O2 Sensor Heater Circuit Malfunction (Bank 1 Sensor 1) P0731 Gear 1 Incorrect Ratio i found the last code, here it is... P1111 Intake Valve Timing Control Solenoid Valve hope this helps
|
|
Size: 72 bytes
