Started 1 week, 6 days ago (2009-12-17 20:55:00)
by Dick
I believe they are sealed. When they finally go, you can get aftermarket units that have zerk fittings. Be prepared to alert your
service center about greasing them when you go in for oil changes.
Started 1 month ago (2009-11-28 16:12:00)
by JVMopar
Seems like most complaints are crankshaft
position sensors, but there are also some for accelerator position sensor, pcm, and EGR.
EGR will cause a stall at idle not while going down the road.
Started 2 weeks, 3 days ago (2009-12-13 21:30:00)
by JVMopar
Looks like they are just bolt on or rivited on. Really shouldn't be too hard to do. If they are rivited cutting the old rivets off and drilling the holes in the control arm would be
the hardest part. They sure are expensive joints though. Napa shows $125 each.
Started 3 weeks ago (2009-12-10 15:23:00)
by RamTrucks RamTrucks is offline Registered User
Thought you’d be interested: Ram HD was just named Motor Trend’s 2010 Truck of the Year! Loads of video, photos, quotes and the latest updates at this
media hub if you need anything:
RamZone dot COM slash RAM HD
Started 4 weeks ago (2009-12-03 15:07:00)
by JVMopar
I'm pretty sure someone makes some block huggers for the
small block. There
was just a discussion on here about Mitsu engines. They moved it to FWD
forum for some reason.
Started 2 months ago (2009-10-26 15:51:00)
by John Kunkel
Welcome to the board.
There is a separate
heat exchanger in the radiator tank so there is no coolant lose when disconnecting the transmission cooler lines.
The sensor tells the PCM when the temperature is too cold or too hot for OD operation.
Can't help with replacement lines other than to say that the braided steel AN rubber hose is often used for transmission cooler lines but I...
Started 1 month, 2 weeks ago (2009-11-14 22:23:00)
by RAM MAN
always sad to see one go ...
Started 1 month, 2 weeks ago (2009-11-12 20:10:00)
by reb
does the 2005 Ram 2500 use the same part. I have a similar problem with my
wipers.
Size: 198 bytes
