|
More site info...
VR - VS Holden Commodore (1993 - 1997) | Forum profile
|
|
Forum profile page for VR - VS Holden Commodore (1993 - 1997) on http://www.justcommodores.com.au.
This report page is the aggregated overview from a single forum: VR - VS Holden Commodore (1993 - 1997) , located on the Message Board at http://www.justcommodores.com.au.
This forum profile page summarizes the general forum statistics such as: Users Activity, Forum Activity, and Top Authors, which are reported in either a table or graph below for a given reporting time period.
Additional forum profile information for "VR - VS Holden Commodore (1993 - 1997) " on the Message Board at http://www.justcommodores.com.au is also shown in the following ways:
1) Latest Active Threads
2) Hot Threads for Last Week
Warning: These statistics are generated using 'best efforts' and can experience delays and reporting errors at times. Please note that such statistics do not constitute a forum's popularity and/or exact posting volumes at any given reporting period.
|
|
|
|
|
Posting activity on VR - VS Holden Commodore (1993 - 1997) :
|
|
Week
|
Month
|
3 Months
|
|
Threads:
|
353
|
1,184
|
2,972
|
|
Post:
|
1,445
|
4,511
|
10,847
|
|
|
VR - VS Holden Commodore (1993 - 1997) Posting activity graph:
|
Top authors during last week:
user's latest post:
urgent need help two cylinders...
Published (2009-12-01 23:56:00)
Another thing,The ECU might be faulty and not firing the injectors,just a thought.The gregorys manual says that the injectors fire from a signal that it gets from the CAS(crank angle sensor)and they are a very common thing to play up,and cause all sorts of problems,it might be worth checking out.
user's latest post:
Just a few questions. - Page 2 -...
Published (2009-12-02 00:08:00)
Will do... Hopefully most of the work that needs done will be done by me mostly... May need a rear main seal replaced too so yea... Loads of work done... When I do the trans service i'll clean up underneath so I can try and find where the leak is... Geh. Leaks but doesnt leak a drip on the ground... Hmm.
user's latest post:
Speed signal and Odometer not...
Published (2009-12-01 22:27:00)
Also wobble/push/pull the wires to the speed sensor as the wires can break inside the insulation due to heat or impact with foreign objects.
user's latest post:
Bottom hose sucking in :( - Page...
Published (2009-12-01 21:56:00)
Quote: Originally Posted by Brucefromruse yur spring has collapsed or taken a ride somewhere, if its in there it WILL NOT collapse. what you mean ? you lost me lol..
user's latest post:
vs engin into a vr
Published (2009-12-02 07:36:00)
Yes. But a little more modification is required than just dropping it in. Use the search button, it's been done a few times.
user's latest post:
vs commodore - Page 2 - Just...
Published (2009-11-28 20:53:00)
just went to depreasurise fuel system an wen i take fuel pump fuse out car wont turn over thats not normal is it ? wat could cause this
user's latest post:
What rims do you have on your ute?
Published (2009-12-01 22:57:00)
A couple of shots of my car with the new 18's, but the car needs a wash badly and sorry about the quality too, its off a mobile phone.
user's latest post:
cops hasling me bout rims... -...
Published (2009-11-29 21:14:00)
Quote: Originally Posted by strgas that wasnt a test just a simple trick question Fact is, the 2in rule is STILL in effect in SA. Point out the window for you sunshine! __________________ ------------------------------------------------------------------------------------------- * * [] [VP CALAIS INTERNATIONAL] [EFI 304] [T56] [] * * * * [] [VP BERLINA LX WAGON] [EFI 304] [T5] [] * *...
user's latest post:
how much would it cost to bore...
Published (2009-12-01 15:14:00)
depends how much money you want to spend... if you don't have much just chuck a 5ltr in and be happy (it'll kick the shit out of a 4.2l stroker). otherwise, buy a 5ltr and stroke that to 355. to get a 5ltr in your car, everything working, $2000 max to get a 355 in your car, everything working, roughly ~$10,000
|
|
|
|
Latest active threads on VR - VS Holden Commodore (1993 - 1997) ::
Started 8 months, 3 weeks ago (2009-03-12 23:31:00)
by hakhawk
moved. my ride section is NOT for posting question threads.
Started 8 months, 3 weeks ago (2009-03-11 11:12:00)
by hsvpunk
For the garnish, try ebay. Thr is always some on ebay, just depends how much u want to spend.
Lowering, kings are good. Are u doing shocks aswell??
Some tyre places will do lowering (just springs) for around the $350-$400
(or do it ya self) (thats them supplyinf the springs, but if u supply, it should only be abt $60-$80 per end of car)
as for exhaust try here. Exhaust Shop ....
Started 1 day, 11 hours ago (2009-12-02 18:44:00)
by WogBoyz
hey everyone
my door handels are kinda faded and so is the rubber at the bottom of the window
im just curious what shud i do to fix it, can i buy new rubbers for the windows n new door handels?
or just respay the handels n trim with the right spray paint
any ideas?
Started 9 months, 3 weeks ago (2009-02-10 11:44:00)
by Zipster
Hi there,
I'm looking for someone that knows well about ALDL ECU. I have this device that is hooked in between the computer and the O2 sensor.
Dual EFIE Deluxe - $114.95 : FuelSaver-MPG Store
And I'm looking for the best setting, an amount of milivolts that the computer can accept without the engine to fail in order to lean my fuel mixture the most I can.
Anyone knows if I add 200mV...
Started 9 months, 3 weeks ago (2009-02-12 15:08:00)
by Zipster
Quote:
Originally Posted by danja
I'd suggest moving this to The Pub, or General as it's not just about VR/VS. Might also get a few more involved in the discussion.
On topic, perhaps you could start by explaining how precisely you have modified your vehicle, what gains you believe you have experienced? There are many different "...
Started 2 days, 9 hours ago (2009-12-01 20:22:00)
by maldotcom2
Sand it all back with wet and dry paper, you dont have to get back to plasic, just smooth. Fill chips with spray putty. Sand back again. Prime and paint.
Started 1 day, 22 hours ago (2009-12-02 07:36:00)
by _R_J_K_
Yes. But a little more modification is required than just dropping it in.
Use the search button, it's been done a few times.
Started 1 day, 22 hours ago (2009-12-02 07:33:00)
by _R_J_K_
Fronts probably will, but I doubt your VN springs will be IRS. I don't think any VN had IRS (or if they did, they were rare). If both cars were live axle, then I'd assume so.
Do you know what brand they are?
Started 2 days, 15 hours ago (2009-12-01 14:41:00)
by pillzor
i dunno but i suspect shitloads as youd have too replace alot of internals aswell and possibly get a custom tune?
Started 2 days, 10 hours ago (2009-12-01 19:34:00)
by customvt
a friend of mine had the same problem with ultra tune with his twin turbo soarer rip off pricks
|
|
Hot threads for last week on VR - VS Holden Commodore (1993 - 1997) ::
Started 4 days, 18 hours ago (2009-11-29 11:14:00)
by strgas
check the load rating on your rims and the factory fitted size rims anything above a plus 2 fittment is considered unroadworthy , Did you get a defect notice for these rims as fitted ???...
Started 1 week, 2 days ago (2009-11-24 22:13:00)
by scozz76
was there a cap on the bottom hose connector that you may not have removed?
Disconnect the bottom hose amd check for water flowing out the bottom of the radiator.
Was the radiator new or second-hand? Possibly blocked.
Started 1 week, 2 days ago (2009-11-24 11:19:00)
by _R_J_K_
Quote:
Originally Posted by burn it
I've checked codes on the computer and it comes up with only 12 ok.
This may sound silly, but 12 will flash 3 times before any other codes are displayed. Is anything else displayed after it has flashed 3 times?
Started 6 days, 14 hours ago (2009-11-27 15:23:00)
by Vee-ard
I found that my VY was a whole lot less reliable than my VR, but that could just be me. It all depends on how well its been looked after. My dad put 300,000 on his VR, and besides regular servicing every 5000kms all he ever needed to change was rotors, a radiator, 2 radiator caps and 3 crank angle sensors.
...
Started 3 days, 17 hours ago (2009-11-30 13:02:00)
by Vee-ard
Not that Im saying it isnt the inlet manifold gasket, (it could be) but it is possible for a head gasket to be stuffed without obvious signs like water in the motor.
Normally at 5,000kms I just change my oil and oil filter (pedantic? yes.), check the water and brake fluid levels.
Started 1 week, 2 days ago (2009-11-24 22:12:00)
by STEALTHY
Could be either, IRS was optional (Only standard on Calais, and maybe SS)
You should upgrade the brAkes either way. Its not like it would ever be wasted money.
Started 4 days, 16 hours ago (2009-11-29 13:09:00)
by strgas
can you hear the pump buzzing when the key is turned to on ??? try switching the fuel pump relay with the horn relay change the fuel pump fuse for a new one ??? any other electrical problems you have noticed ???
Started 2 days, 19 hours ago (2009-12-01 10:27:00)
by ducker85
last weeks VR ride height thread here contain the eye brow heights you need to know in SA.
VS is 360mm (front) and 350mm (rear).
Started 2 weeks, 1 day ago (2009-11-18 20:24:00)
by hako
Probably the battery - if it's over 2 years old it may be due for replacement. A good test is to turn the headlights on when you crank - if it cranks really slow you can be sure the battery has lost some of it's capacity.
Started 3 days, 9 hours ago (2009-11-30 20:15:00)
by hako
Gap the plug down to 1.0mm and see if it fires.
|
|
Size: 112 bytes
