Tips & Tricks | Forum profile

Forum profile page for Tips & Tricks on http://harleyzone.tenmagazines.com. This report page is the aggregated overview from a single forum: Tips & Tricks, located on the Message Board at http://harleyzone.tenmagazines.com. This forum profile page summarizes the general forum statistics such as: Users Activity, Forum Activity, and Top Authors, which are reported in either a table or graph below for a given reporting time period. Additional forum profile information for "Tips & Tricks" on the Message Board at http://harleyzone.tenmagazines.com is also shown in the following ways:

1) Latest Active Threads
2) Hot Threads for Last Week

Warning: These statistics are generated using 'best efforts' and can experience delays and reporting errors at times. Please note that such statistics do not constitute a forum's popularity and/or exact posting volumes at any given reporting period.

Site:	Harley Zone Forums (site profile, domain info tenmagazines.com)
Title:	Tips & Tricks
Url:	http://harleyzone.tenmagazines.com/ew/forum.asp...
Users activity:	46 posts per thread
Forum activity:	0 active threads during last week

Posting activity on Tips & Tricks:

	Week	Month	3 Months
Threads:	0	0	9
Post:	0	0	41

Tips & Tricks Posting activity graph:

Posts by: day week month

Top authors during last week:

No active authors during last week.

Latest active threads on Tips & Tricks::

RE: Harley Zone

Started 1 month ago (2009-11-14 14:19:00) by tattoo

I have seen a softail with that set up. I didnt ride it...

Thread: Show this thread (3 posts)

Size: 134 bytes
Related Threads: Same Site | All Sites
Customize:

RE: Harley Zone

Started 5 months ago (2009-07-22 21:23:00) by yubnub

I had my 2003 flhtc in for a new engine and I commented to my service rep that I had way too much play with that shaft and could not tighten the bolt anymore. Thank goodness I had the extended warranty. He gave me the impression that they did the repair with the transmission in place. The shafts are too soft and they tear out the splines. Harley does know about it as the service rep ...

Thread: Show this thread (22 posts)

Size: 662 bytes
Related Threads: Same Site | All Sites
Customize:

RE: Harley Zone

Started 2 months, 4 weeks ago (2009-09-24 08:44:00) by TIPPY

yea ok...and I'll keep a pocket full of rubber bands for your "TWIN" cams too

Thread: Show this thread (4 posts)

Size: 294 bytes
Related Threads: Same Site | All Sites
Customize:

RE: Vibration Topic - Harley Zone

Started 2 years, 8 months ago (2007-04-23 20:51:00) by Triplate

Tighter the better ...use blue loctite.............you change out the rubber mounts at the rear of the mufflers?? ..they get hard and will magnifu any vibration...you change the exhaust gaskets and made sure the pipe was tight too the head? How bout the joint where the muffler attches with that copper donut ??..you change those ?

Thread: Show this thread (19 posts)

Size: 406 bytes
Related Threads: Same Site | All Sites
Customize:

RE: Harley Zone

Started 3 months ago (2009-09-20 13:24:00) by Henryj

I bought the Fram from Wally World also. Looked Like half of the innards were missing. I chose not to use it.

Thread: Show this thread (13 posts)

Size: 186 bytes
Related Threads: Same Site | All Sites
Customize:

Hot threads for last week on Tips & Tricks::

No active threads for last week.