Philips HDTV Sets | Forum profile

Forum profile page for Philips HDTV Sets on http://www.hdtvocie.com. This report page is the aggregated overview from a single forum: Philips HDTV Sets, located on the Message Board at http://www.hdtvocie.com. This forum profile page summarizes the general forum statistics such as: Users Activity, Forum Activity, and Top Authors, which are reported in either a table or graph below for a given reporting time period. Additional forum profile information for "Philips HDTV Sets" on the Message Board at http://www.hdtvocie.com is also shown in the following ways:

1) Latest Active Threads
2) Hot Threads for Last Week

Warning: These statistics are generated using 'best efforts' and can experience delays and reporting errors at times. Please note that such statistics do not constitute a forum's popularity and/or exact posting volumes at any given reporting period.

Site:	HDTVoice.com - High-Definition Television Talk - HDTV Discussion Forum (site profile)
Title:	Philips HDTV Sets
Url:	http://www.hdtvoice.com/voice/forumdisplay.php?...
Users activity:	16 post per thread
Forum activity:	0 active threads during last week

Posting activity on Philips HDTV Sets:

	Week	Month	3 Months
Threads:	0	1	8
Post:	0	2	13

Philips HDTV Sets Posting activity graph:

Posts by: day week month

Top authors during last week:

No active authors during last week.

Latest active threads on Philips HDTV Sets::

HDTVoice.com - High-Definition Television Talk - HDTV Discussion Forum

Philips 34PW850H37F problem

Started 3 weeks, 3 days ago (2009-11-18 01:44:00) by soulbreaker360

Philips 34PW850H37F problem So this is a really nice tv....but on the component input when displaying in 1080i...the left side is cut off by about an inch which annoys me because i am all about great picture... Ive been researching the service menu and found this link http://www.hdtvoice.com/voice/showthread.php?t=891 7 and think it might ...

Thread: Show this thread (2 posts)

Size: 719 bytes
Related Threads: Same Site | All Sites
Customize:

RE: 60pp9202 convergence ic's???????

Started 3 years, 5 months ago (2006-07-10 11:36:00) by 57U

See the sticky on convergence problems at the top of the Hitachi forum. The ICs are usually soldered to a heat sink. They may not be the only thing wrong - there could also be blown resistors.

Thread: Show this thread (85 posts)

Size: 192 bytes
Related Threads: Same Site | All Sites
Customize:

RE: Can't update firmware..42PF7220A/37

Started 2 months ago (2009-10-13 09:00:00) by Ratman

Here are the instuctions: http://www.p4c.philips.com/cgi-bin/..._37_fur_aen. pdf Take note: Only FAT/ DOS- formatted port a ble memory is supported

Thread: Show this thread (5 posts)

Size: 551 bytes
Related Threads: Same Site | All Sites
Customize:

RE: Bad Firmware Update, No Philips Support!! 60PL9200D/37

Started 2 months, 2 weeks ago (2009-09-25 01:27:00) by Neutron

So I've been going through the posts and realize too much "overscan" is the problem. I've downloaded the service manual and entered the service menu of the TV. There does not appear to be any adjustment for overscan, vertical, or horizontal strech. There was no or very little overscan before the firmware update and now I would say it is about 15%. It cuts off the top and bottom of my ...

Thread: Show this thread (3 posts)

Size: 779 bytes
Related Threads: Same Site | All Sites
Customize:

Hot threads for last week on Philips HDTV Sets::

No active threads for last week.