Panasonic HDTV Sets | Forum profile

I had to re-install FM today and now when I load it up all I get is a black screen, it does the loading up screens fine but once you get to the main menu, black screen.Any ideas?

Three blinks is usually a convergence output failure. May involve fuses and resistors as well.

At a minimum, you should set the TV picture to Standard. If you have the manual, it will tell you how to access the video options. The aspect ratio should be set to 16:9. HD programs are in the 16:9 format. Standard definition programs are in 4:3. Because you are using plasma, those programs should be set to 16:9 to further reduce the chance of burn in. If you have an HDMI cable, I...

If the colours are lined up and the picture is bowed, perhaps the convergence ICs are OK, but the convergence lines need to be straightened. This is usually done in the manual convergence using an overlay or strings taped to the TV screen at the correct points. You then line up the green CRT to the strings/overlay and then converge the blue and red to the green. This can take some time - a ...

Well... if someone could throw me a bone on this...I don't know if lack of responses is a "Geez, didn't this idiot read the threads?" or if no one has any suggestions. I DID read all the convergence threads and removed and resoldered everything I replaced 3 times now and am confident it's all good connections. I talked to a reputable electronics shop who said that pretty much if it's not ...

I have the exact same problem, and would also like to know what the value of these are... thanks for any help...

Check your TV's setup options for the HDMI input and see if there is an option for 1:1 pixel mapping (no overscan). If so, enable that option. EDIT: Your model TV doesn't appear to have a 1:1 option. Page 54 of your manual outlines the support resolutions for HDMI. Have you tried "matching" your PC's settings? Quote: 525 (480) / 60i 15.73 59.94 * *...