Infiniti Q45 and 03/04 M45 | Forum profile

WOW! really...... So I plug in the IPOD an nothing happens...I'm just staring at my radio. Then a little voice says: put a blank cd in to 'trigger it'...... much better!!

There are not many things that will cause your car to go into limp mode. they are: no CAS readings. No MAF readings, out of range MAF readings will usually simply throw a check engine code and one third thing I dont remember right now. <

Rod is going to hook me up with my radio. Can't wait til the weather get better so i can have my radio modded

I can say without hesitation that this is the nicest car I've ever owned. I turns out that the rear brake caliper wasn't bad after all. One of the guide pins hadn't been greased and had a bit of surface rust. A quick polish and some silicone brake grease saved me a nice chunk of change. Unfortunately, it seems that once you start giving a car attenttion, it wants more. After having it in the warm shop for a couple hours, I went...

The car is gorgeous man. Congratulations. Rod

Nice! It looks really clean.

Congrats on your 94Q purchased. Fred is right on spot in changing all fluids. When I bought my 94Q I wasted no time and took it to the dealership to replace all fluids.

The strange thing is that it happens during normal driving and acceleration. No particular speed or driving condition. Seems to go into limp mode. Car is a 2004 M45 with only about 18k miles on it....no CEL either.

Don't rely on the absence of CEL always scan with OBD2 scan tool as some problems won't always illuminate light or worse lights can burn out or fail to trigger. As to failing just after warranty expires: I would give engineers a bonus for cutting it close to edge. After all vehicles which last too long hurt stockholders, which require a constant selling of product. years! We must make them fail faster so new ones are purchased.

For those wondering, I just had my SRS airbag light go into flashing mode. Dealer said no go on any warranty on my 02 Q. I did a check on the internet and found that if you turn the key so all the lights come on, don't start the engine, and wait until the airbag light turns off, but before it starts blinking, turn the key to the off position. Wait 3 seconds and do it all over again, 3 or 4 times. After those cycles, wait 5 or 6 seconds...