|
More site info...
Modified 1995-2001 Explorers | Forum profile
|
|
Forum profile page for Modified 1995-2001 Explorers on http://www.explorerforum.com.
This report page is the aggregated overview from a single forum: Modified 1995-2001 Explorers, located on the Message Board at http://www.explorerforum.com.
This forum profile page summarizes the general forum statistics such as: Users Activity, Forum Activity, and Top Authors, which are reported in either a table or graph below for a given reporting time period.
Additional forum profile information for "Modified 1995-2001 Explorers" on the Message Board at http://www.explorerforum.com is also shown in the following ways:
1) Latest Active Threads
2) Hot Threads for Last Week
Warning: These statistics are generated using 'best efforts' and can experience delays and reporting errors at times. Please note that such statistics do not constitute a forum's popularity and/or exact posting volumes at any given reporting period.
|
|
|
|
|
Posting activity on Modified 1995-2001 Explorers:
|
|
Week
|
Month
|
3 Months
|
|
Threads:
|
30
|
290
|
892
|
|
Post:
|
90
|
947
|
2,840
|
|
|
Modified 1995-2001 Explorers Posting activity graph:
|
Top authors during last week:
user's latest post:
Installing my TM Headers this...
Published (2008-11-27 15:35:00)
I gave up for the day, but also because of Thanksgiving lunch and the family came over. I can't get the EGR tube off of the EGR solenoid on the back of the intake manifold. It's rusted on there good. I might just have to go buy a new EGR solenoid from Ford tomorrow.
user's latest post:
When is boost not noost?
Published (2008-11-26 19:30:00)
I believe you are still getting the 6lb of boost because you don't have all of the restriction with the stock headers so now the exhaust is able to move freely, i am going to have the same problem when i put headers on my explorer with the x-charger on it.
user's latest post:
Installing my TM Headers this...
Published (2008-11-27 11:54:00)
Believe it or not, I have a 5 foot long 1/2 in drive extension that works on that bolt. You snake it in from WAY back with a wobble socket. I bought the extension to unbolt bellhousing bolts on 4WD vehicles when I had to rebuild the trans. Tighten both bolts together, but make sure the inside gets snugged first. That way when you finish up on the outside bolt, the flange tension will actually "tighten" the inside bolt for you...
user's latest post:
Help with Dual Exhaust set up...
Published (2008-11-28 02:43:00)
Take the spare out from underneath it and ditch it if you have roadside assistance. If not, throw it in the back of the truck. Also I know there is a spare tire mount thread on here somewhere for mounting it in the cargo area. Use the search for that if thats something you would be interested in.
user's latest post:
SCT tuning
Published (2008-11-27 22:40:00)
Some people said that their transmissions shifted a lot smoother, and their idle speed was more on the steady side after the tune. I'm sure that it will improve over all performance, and gas mileage.
user's latest post:
Couple videos of my 01 explorer
Published (2008-11-26 12:29:00)
No mufflers or glass packs? Either way that thing needs a muffler, bad! It could sound sooo much better. Unless you like that '40s lowrider sound from an SUV. Good luck this weekend with the rest of the mods. All of that should make quite the difference!
user's latest post:
SCT tuning
Published (2008-11-27 23:09:00)
Quote: Originally Posted by Fordexplorer140k Is the out come of a tune worth the money and time Most definitely. The time is irrelevant; it takes less than 10 minutes to load the tune.
|
|
|
|
Latest active threads on Modified 1995-2001 Explorers::
Started 6 days, 14 hours ago (2008-11-28 03:59:00)
by adambodkins
Well as I posted in my "OCD" thread I installed my billet grille the other day and well I have a problem. I went to start measuring for my CAI today while waiting for the wife to finish cooking and low and behold. I can't get my fingers in the grille to pop the hood. HOW do I get the hood popped without having to stick a flathead in the grille to release the hood latch? The grille I ordered came ...
Started 6 days, 16 hours ago (2008-11-28 01:28:00)
by jayjaylenhenson7
Earlier today I tried to get a 1 In /2 Out Flowmaster(40 series) for my Sport 2door, the only thing that stopped progress was that damn spare tire mounted underneath the ass end of the truck. Can someone point me in the right direction on what to do about the spare? I really want two guns out the back but concealed behind the bumper and with the tire there I dont see a logical way of that ...
Started 1 week ago (2008-11-27 14:59:00)
by Spdrcer34
Okay...I am going to remove the dash out of my `97 X, and swap it into my `92.... I am also swapping over to EATC, and adding the Console Computer while it's out, and since I am also pulling the HVAC box, I am replacing the Blend Door... Couple of OTHER questions for you guys... Is the Dorman Blend Door built any better than the OEM door? Or does it suffer the same weak spot ...
Started 6 days, 17 hours ago (2008-11-28 00:35:00)
by ramren16
not sure where to put this question. it is probably a stupid one but what causes a vehicle to shock you when i get out, it seems like some kinda static charge of some kind. just curious i dont like getting shocked every time i exit my vehicle
Started 1 week ago (2008-11-27 11:20:00)
by Fordexplorer140k
Ive searched this site and i cant seem to get an answer, What exactly does the sct do? i rather someone with personal experience answer or if anyone can send me a thread link that would be great. THANKS!
Started 6 days, 21 hours ago (2008-11-27 21:00:00)
by jrpackman
My center console is worn real bad. I have been thinking about removing it and puting one is that goes all the way to the dash. Just wondering what you guys have done in your explorers?
Started 1 week ago (2008-11-27 07:33:00)
by N8IWS
I think my AWD case is going bad after 300,000 miles. Yesterday driving it was very hard to turn the steering wheel unless I depressed the accelerator, then steered fine. I have the transfer case from my 2000 5r55e replacement and it only has 6000 miles on it. Has anyone looked at using this as a replacement? I have looked at the 4406 manual write up and considering this after winter. ...
Started 1 week, 5 days ago (2008-11-22 17:43:00)
by SilverBullet
I can't the get collector bolts loose for the life of me. The outside one on the passenger side, I rounded the head off. The inside one I tried for awhile with no luck... the drivers side I can't budge. Granted, I'm using only hand tools. Tomorrow I will try an impact gun. Also, I broke several of those stupid small hard vacuum lines just by looking at them. Argh.
Started 1 week ago (2008-11-27 06:21:00)
by graywolf1
muffler for my 99 xlt any Ideas and hello to everyoneItsa 5.0 with dual cats and i just want to replace the muffler with a decent sound to it
Started 1 year, 7 months ago (2007-04-29 17:41:00)
by mwezlo
does anybody have a vid or sound clip of there mac bolt on exhaust. im looking to get one so id like to hear what it sounds like
|
|
Hot threads for last week on Modified 1995-2001 Explorers::
Started 1 week, 1 day ago (2008-11-25 23:03:00)
by steveofire
Here are a couple videos of my 01 5.0 supercharged explorer. Right now it has the stock tune but going to be doing some upgrading next week and will post some new videos when that is done. Let me know what ya think. YouTube Video If you are able to see this message it means that you don't have flash installed or that ...
Started 1 week, 2 days ago (2008-11-25 13:08:00)
by redemption5525
Wondering if anyone has done a write up of a 4" superlift install, or knows what all is needed. In colorado, is there anyone on here from colorado that knows how too install a superlift?
Started 1 week, 5 days ago (2008-11-22 17:43:00)
by SilverBullet
I can't the get collector bolts loose for the life of me. The outside one on the passenger side, I rounded the head off. The inside one I tried for awhile with no luck... the drivers side I can't budge. Granted, I'm using only hand tools. Tomorrow I will try an impact gun. Also, I broke several of those stupid small hard vacuum lines just by looking at them. Argh.
Started 1 week ago (2008-11-27 11:20:00)
by Fordexplorer140k
Ive searched this site and i cant seem to get an answer, What exactly does the sct do? i rather someone with personal experience answer or if anyone can send me a thread link that would be great. THANKS!
Started 1 week, 1 day ago (2008-11-26 15:48:00)
by Kris02sport
i have a question... can anyone tell what front end lift this is? its on a 03 sport 2WD because ive searched everywhere and i cant find any lift that has those kind of upper shock hoops like that i had planned to lift my car with 3in doetsch spindles, 3in body lift, and 4in superlift rear end. and have 33's but if i can find out what front ...
Started 1 week, 6 days ago (2008-11-21 03:03:00)
by muhl5443
So i decided to put a remote starte in my x. it took me no more than an hour to do and i did it with out a bypass module in my '98 xlt. i will do a write up later. since i have scoured this site and not seen one done on remote starter installs. all i paid was $79.04.
Started 1 week ago (2008-11-27 07:33:00)
by N8IWS
I think my AWD case is going bad after 300,000 miles. Yesterday driving it was very hard to turn the steering wheel unless I depressed the accelerator, then steered fine. I have the transfer case from my 2000 5r55e replacement and it only has 6000 miles on it. Has anyone looked at using this as a replacement? I have looked at the 4406 manual write up and considering this after winter. ...
Started 1 week ago (2008-11-27 06:21:00)
by graywolf1
muffler for my 99 xlt any Ideas and hello to everyoneItsa 5.0 with dual cats and i just want to replace the muffler with a decent sound to it
Started 1 week ago (2008-11-27 14:59:00)
by Spdrcer34
Okay...I am going to remove the dash out of my `97 X, and swap it into my `92.... I am also swapping over to EATC, and adding the Console Computer while it's out, and since I am also pulling the HVAC box, I am replacing the Blend Door... Couple of OTHER questions for you guys... Is the Dorman Blend Door built any better than the OEM door? Or does it suffer the same weak spot ...
| |
