|
More site info...
Ford Taurus | Mercury Sable | Ford Taurus SHO | 1986-2007 | Forum profile
|
|
Forum profile page for Ford Taurus | Mercury Sable | Ford Taurus SHO | 1986-2007 on http://www.fordforums.com.
This report page is the aggregated overview from a single forum: Ford Taurus | Mercury Sable | Ford Taurus SHO | 1986-2007, located on the Message Board at http://www.fordforums.com.
This forum profile page summarizes the general forum statistics such as: Users Activity, Forum Activity, and Top Authors, which are reported in either a table or graph below for a given reporting time period.
Additional forum profile information for "Ford Taurus | Mercury Sable | Ford Taurus SHO | 1986-2007" on the Message Board at http://www.fordforums.com is also shown in the following ways:
1) Latest Active Threads
2) Hot Threads for Last Week
Warning: These statistics are generated using 'best efforts' and can experience delays and reporting errors at times. Please note that such statistics do not constitute a forum's popularity and/or exact posting volumes at any given reporting period.
|
|
|
|
|
Posting activity on Ford Taurus | Mercury Sable | Ford Taurus SHO | 1986-2007:
|
|
Week
|
Month
|
3 Months
|
|
Threads:
|
10
|
41
|
168
|
|
Post:
|
31
|
124
|
416
|
|
|
Ford Taurus | Mercury Sable | Ford Taurus SHO | 1986-2007 Posting activity graph:
|
Top authors during last week:
user's latest post:
Heater/AC runtime problem - Page...
Published (2009-12-20 18:00:00)
Back to you Bert, I TOTALLY appreciate the feedback from you and the guys! May everyone have a well-tuned, unbreakable Christmas!
user's latest post:
'99 Taurus - runs rough...
Published (2009-12-20 20:48:00)
I should have said IAC voltage. Some manufactures call it that, You were checking the voltage I mentioned. Cleaning the throttle body is fairly easy. Take the hose off, open the throttle and clean the area inside. You can also take the IAC valve off and clean it too. Don't forget the MAF.
user's latest post:
Heater/AC runtime problem - Page...
Published (2009-12-18 09:25:00)
The running compressor is used for preheat and defrost over ride. It should not run in " heat " or " vent ". Pulling the fuse could set an engine code and shut down your engine cooling fan. Not recommended. Get it fixed if you can.
user's latest post:
Heater/AC runtime problem - Page...
Published (2009-12-18 02:48:00)
It would just unplug compressor. Have you tried using the vent setting? The compressor should not run in that position. (one notch to the left of off)
user's latest post:
'99 Taurus - runs rough...
Published (2009-12-20 20:39:00)
No engine codes. I haven't messed with the idle screw, either. I'm a little hesitant to get into the throttle body though, because I've never played with one before. Sounds like cleaning it is a good start. Dumb questions, but what is the "bypass passage?" And how do I go about cleaning the throttle body? Thanks for the thoughts.
user's latest post:
91 Sable Will Crank Over But...
Published (2009-12-14 08:28:00)
Just wanted to let you guys know dad is having is friend Gary come over & see if he can figure out what is wrong with the car. We've tried everything everybody's told to & still no luck. He's suppose to have come over Saturday, but I haven't talk to dad yet to see if lhe did. As soon as I hear anything I'll be sure to let you guys know.
user's latest post:
radio question
Published (2009-12-12 21:26:00)
Does the radio for a 2000 mercury sable, the one with electronic/digital heater controls below it, have RCA in-puts on back for the optional cd changer?
user's latest post:
radio question
Published (2009-12-12 23:13:00)
Quote : Originally Posted by eckstei4 Does the radio for a 2000 mercury sable, the one with electronic/digital heater controls below it, have RCA in-puts on back for the optional cd changer? No. I'm not sure on the vehicles with a full console (because around 2000 redesign, the changer was moved to the inside of the console) On 6 passenger cars (changer in trunk) the changer plugs directly into the rear chassis unit (actual radio...
user's latest post:
3.0L OHV flex fuel exhaust valve
Published (2009-12-15 17:49:00)
PM me the part number and vin to your car, I'll get you what you need before the end of the week.
user's latest post:
3.0L OHV flex fuel exhaust valve
Published (2009-12-15 16:12:00)
I am trying to locate an exhaust valve for a 3.0L OHV flex fuel engine. I ordered one from the dealer but got the wrong size valve. The diameter of the valve was 1.37" and the one that is in the car is 1.66". Ford only shows one part # for an exhaust valve for this engine. Has anyone run into this problem?
|
|
|
|
Latest active threads on Ford Taurus | Mercury Sable | Ford Taurus SHO | 1986-2007::
Started 1 year, 4 months ago (2008-08-18 01:06:23)
by mzmanniefresh
im having a big problem with my 99 taurus. when i put my car into the drive position and press lightly on the gas the car will not move. when i press harder on the gas petal it will make a roaring noise and the rpm will go way pass the number 4 and the car will jump and move just a little. the car will trickle along very slowly. when im at red lights my car will not move it will just sit while ...
Started 1 week ago (2009-12-16 08:55:00)
by rtg143
Have you checked for codes? Autozone will do it for free. The coil could possibly be bad even with the readings showing okay.
Started 1 year, 5 months ago (2008-07-18 19:36:00)
by mre_power
it is possible just swap in all sensors. might need some machining. also cap over distributor hole and add cam sync sensor.
one thing you may want to check first is if the cam position sensor is bad on the old engine that part being replaced may fix the problem because if the gear at the end of the sensor goes or starts to go the oil pump quits spinning. your oil pump may still be ...
Started 1 year, 4 months ago (2008-08-07 17:31:00)
by tbird100636
Re: 2001 Rear Strut Removal, cant hold the shaft to get the nut off!
Quote :
Originally Posted by RSLT1
I cannot for the life of me hold the shaft from not spinning to get the top nut off from inside. I tried vice grips but no luck!
With the strut in...
Started 1 month ago (2009-11-21 15:38:00)
by Sterling_Six
Quote :
Originally Posted by Neill 442
I have a 2000 Taurus SES 3.0L automatic at the end of winter last year the heat was poor and has not gotten any better. So far I have replace the thermostat,Flushed the cooling system inclueding removing the hoses at the heater core to flush it and today replaced the water pump. I still have ...
Started 1 year, 11 months ago (2008-01-25 18:37:00)
by jwko
Re: 91' Taurus Heat Problem
I would suspect a bad thermostat.
Started 1 week, 3 days ago (2009-12-12 23:13:00)
by tbird100636
Quote :
Originally Posted by eckstei4
Does the radio for a 2000 mercury sable, the one with electronic/digital heater controls below it, have RCA in-puts on back for the optional cd changer?
No. I'm not sure on the vehicles with a full console (because around 2000 redesign, the changer was moved to the inside ...
Started 1 week, 5 days ago (2009-12-10 14:25:00)
by jwko
I have some photos I took of my 01 before I sold it. Hope they help
Started 1 year, 9 months ago (2008-03-12 00:00:00)
by Old 07-09-2008, 00:06
Started 2 weeks, 1 day ago (2009-12-07 16:44:00)
by rtg143
If it has disc brakes, remove rear disc brake caliper from rear disc brake adapter and hang out of way with a piece of wire. Remove rear disc brake rotor, wheel hub, rear wheel disc brake shield, and rear brake anti-lock sensor.
If it has drum brakes, remove brake drum and wheel hub. Remove four bolts retaining brake backing plate to the rear wheel spindle. Remove brake backing plate from ...
|
|
Hot threads for last week on Ford Taurus | Mercury Sable | Ford Taurus SHO | 1986-2007::
Started 1 week ago (2009-12-16 08:55:00)
by rtg143
Have you checked for codes? Autozone will do it for free. The coil could possibly be bad even with the readings showing okay.
Started 1 year, 4 months ago (2008-08-18 01:06:23)
by mzmanniefresh
im having a big problem with my 99 taurus. when i put my car into the drive position and press lightly on the gas the car will not move. when i press harder on the gas petal it will make a roaring noise and the rpm will go way pass the number 4 and the car will jump and move just a little. the car will trickle along very slowly. when im at red lights my car will not move it will just sit while ...
Started 1 year, 5 months ago (2008-07-18 19:36:00)
by mre_power
it is possible just swap in all sensors. might need some machining. also cap over distributor hole and add cam sync sensor.
one thing you may want to check first is if the cam position sensor is bad on the old engine that part being replaced may fix the problem because if the gear at the end of the sensor goes or starts to go the oil pump quits spinning. your oil pump may still be ...
Started 1 year, 4 months ago (2008-08-07 17:31:00)
by tbird100636
Re: 2001 Rear Strut Removal, cant hold the shaft to get the nut off!
Quote :
Originally Posted by RSLT1
I cannot for the life of me hold the shaft from not spinning to get the top nut off from inside. I tried vice grips but no luck!
With the strut in...
Started 1 year, 11 months ago (2008-01-25 18:37:00)
by jwko
Re: 91' Taurus Heat Problem
I would suspect a bad thermostat.
Started 1 month ago (2009-11-21 15:38:00)
by Sterling_Six
Quote :
Originally Posted by Neill 442
I have a 2000 Taurus SES 3.0L automatic at the end of winter last year the heat was poor and has not gotten any better. So far I have replace the thermostat,Flushed the cooling system inclueding removing the hoses at the heater core to flush it and today replaced the water pump. I still have ...
|
|
Size: 848 bytes
