|
More site info...
Wiring, Electrical and Installation Help | Forum profile
|
|
Forum profile page for Wiring, Electrical and Installation Help on http://www.caraudio.com.
This report page is the aggregated overview from a single forum: Wiring, Electrical and Installation Help, located on the Message Board at http://www.caraudio.com.
This forum profile page summarizes the general forum statistics such as: Users Activity, Forum Activity, and Top Authors, which are reported in either a table or graph below for a given reporting time period.
Additional forum profile information for "Wiring, Electrical and Installation Help" on the Message Board at http://www.caraudio.com is also shown in the following ways:
1) Latest Active Threads
2) Hot Threads for Last Week
Warning: These statistics are generated using 'best efforts' and can experience delays and reporting errors at times. Please note that such statistics do not constitute a forum's popularity and/or exact posting volumes at any given reporting period.
|
|
|
|
|
Posting activity on Wiring, Electrical and Installation Help:
|
|
Week
|
Month
|
3 Months
|
|
Threads:
|
140
|
585
|
1,617
|
|
Post:
|
501
|
2,741
|
8,224
|
|
|
Wiring, Electrical and Installation Help Posting activity graph:
|
Top authors during last week:
user's latest post:
This battery still good or what?...
Published (2009-12-01 07:17:00)
Quote: Originally Posted by quins90lac Yeah but his shit is great and you cant argue that. And you cant blame a guy for trying to promote his company. uh, yeah I can. It pretty much negates any advice he's trying to give because there's so much bias in his post I can't tell what the truth is...
user's latest post:
Stock Speaker Wire?
Published (2009-12-01 12:39:00)
Quote: Originally Posted by ArcFault I decided to play it safe and rather then using 8gauge like I could have for my set up I have 10gauge speaker wire 8 gauge for speaker wire?! I've never heard of that. or maybe you're talking about from your amp to your subs? OP's post is about regular speakers.
user's latest post:
i have problems someone hel[p -...
Published (2009-11-29 08:39:00)
Quote: Originally Posted by x1le No settings on the amp are going to make it randomly cut in and out, unless you have the gain and bass boost too high and it's clipping. Might just be a bad connection in the amp itself. Maybe check the voltage of your remote wire with music playing? The voltage dipping could also turn the amp on/off and would be an easy fix. well i didnt notice any voltage dip while it was on.....im gonna meet up with a...
user's latest post:
1996 lexus ls400 wiring harness...
Published (2009-12-01 13:40:00)
well i was just outside looking at the wires and i was wrong about the colors..thers a white, gray, and blue one. but i found the one you wer talking about. but my question is, do i only use those 4 wires out of that plug? and will i need any wires from the other 2 plugs?
user's latest post:
Official CarAudio.com Big 3...
Published (2009-12-02 20:10:00)
Thanks jkbauemont. I appreciate the response. its going to my Fuze box, not my battery. could I run the new one from alt to fuze positive terminal like the old, or is it better to go directly to the battery? Also if ur silverado is similar where was the wire at, was it more on the bottom or under side. Im going from memory so dont remember seing any other wires, but I will check tomorrow while doing my gains and hopefully finish the BIG 3 also...
user's latest post:
think this is good wire?
Published (2009-12-02 00:41:00)
what kind of wire? gauge? you gave us nothing
user's latest post:
Isn't it theoretically...
Published (2009-12-02 23:54:00)
lol ill tell you guys how it goes. now i need 50 ft of 1/0
user's latest post:
Dual battery wiring tutorial...
Published (2009-12-02 18:00:00)
Just bought a batcap 4000, my front hc1400 is dead after autozone tested it. Is it necessary to get an isolator, i was thinking of the Stinger 200amp isolator on ebay, but my alt does 230amp. My rear hc1400 will be switched to the front and the batcap 2000 will be in the trunk..
|
|
|
|
Latest active threads on Wiring, Electrical and Installation Help::
Started 3 days, 14 hours ago (2009-12-02 18:04:00)
by Kevinn
Quote:
Originally Posted by skylineTT
just run 0 gauge from alternator posi to battery posi, alternator ground to batt negative, 2 power wires from the battery to the amp positive and negative? i want to do the big 3 with 2/0 and a posi and neg from the batt to the amp, but then thought that i might as well run a wire from the alt ...
Started 3 days, 10 hours ago (2009-12-02 21:53:00)
by SicAudio
more than 500 watts and that sub is gonna smoke lolz set the gains and turn the bass stuff on the deck all off!
Started 3 years, 5 months ago (2006-07-05 18:37:00)
by ultimate157
Here's my setup right now:
8-Gauge wire battery + running to my 200w rms 600 peak RF amp for my subs.
8-Gauge wire battery + running to my 100w rms 400 peak Jensen amp for my
surrounds.
Both are grounded close to the amps to the chassis with a clean ground. My
lights dim pretty badly with such little power. It looks like my chassis to
battery ground is a mere 8-gauge wire. If I run 8-Gauge from...
Started 6 days, 17 hours ago (2009-11-29 14:51:00)
by fasfocus00
so you're saying that the car is not moving and that a no sound producing
object in the car is producing sound?
Started 3 days, 16 hours ago (2009-12-02 16:22:00)
by k_schutte
that would be fine... you running another amp at all?
you should be good just doing the Big3 if that is your only amp, then you don't have to waste money on batts... depending on the car.
Started 7 months, 3 weeks ago (2009-04-13 11:11:00)
by Stephen_c
why the batterys gotta be yellow?
Started 3 days, 17 hours ago (2009-12-02 14:37:00)
by CrownVicon24's
Quote:
Originally Posted by SWFL
My electrical consist of
242 max 178 at idle amps DC Power Alt
big 3 in 1/0 doubled up
duralast gold upfront.
2 power runs of 1/0 klmx to the back
2 ground runs of 1/0 klmx to the back
back batteries are 3 C&D 135AH batts all connected in 1/0 and 1/0 to the amp
The amp is a RD D9. I ...
Started 4 days, 8 hours ago (2009-12-02 00:35:00)
by basscort2009
|
|
Hot threads for last week on Wiring, Electrical and Installation Help::
Started 6 days, 10 hours ago (2009-11-29 22:07:00)
by 1mtx1
Started 4 days, 8 hours ago (2009-12-02 00:35:00)
by basscort2009
Started 1 week ago (2009-11-28 12:30:00)
by x1le
Started 5 days, 18 hours ago (2009-11-30 14:10:00)
by Tommyb
also when i took the factory stereo out, i saw 3 different harnesses. but in the wiring harnesses that i have found they only have 2.
so can someone explain to me what each of the 3 harnesses are?
Started 3 days, 16 hours ago (2009-12-02 16:22:00)
by k_schutte
that would be fine... you running another amp at all?
you should be good just doing the Big3 if that is your only amp, then you don't have to waste money on batts... depending on the car.
Started 4 days, 12 hours ago (2009-12-01 20:17:00)
by SPLluminator
Started 6 days, 9 hours ago (2009-11-29 22:59:00)
by Horsemanwill
have u checked ur brakes?
Started 6 days, 17 hours ago (2009-11-29 14:51:00)
by fasfocus00
so you're saying that the car is not moving and that a no sound producing
object in the car is producing sound?
Started 3 days, 17 hours ago (2009-12-02 14:37:00)
by CrownVicon24's
Quote:
Originally Posted by SWFL
My electrical consist of
242 max 178 at idle amps DC Power Alt
big 3 in 1/0 doubled up
duralast gold upfront.
2 power runs of 1/0 klmx to the back
2 ground runs of 1/0 klmx to the back
back batteries are 3 C&D 135AH batts all connected in 1/0 and 1/0 to the amp
The amp is a RD D9. I ...
Started 1 week, 1 day ago (2009-11-27 23:39:00)
by dafobbishon3
grounding in the truck alone. you don't want your ground to be more the 3
ft long.
|
|
Size: 1,044 bytes
