|
More site info...
Car Audio: General | Forum profile
|
|
Forum profile page for Car Audio: General on http://www.caraudioforum.com.
This report page is the aggregated overview from a single forum: Car Audio: General, located on the Message Board at http://www.caraudioforum.com.
This forum profile page summarizes the general forum statistics such as: Users Activity, Forum Activity, and Top Authors, which are reported in either a table or graph below for a given reporting time period.
Additional forum profile information for "Car Audio: General" on the Message Board at http://www.caraudioforum.com is also shown in the following ways:
1) Latest Active Threads
2) Hot Threads for Last Week
Warning: These statistics are generated using 'best efforts' and can experience delays and reporting errors at times. Please note that such statistics do not constitute a forum's popularity and/or exact posting volumes at any given reporting period.
|
|
|
|
|
Posting activity on Car Audio: General:
|
|
Week
|
Month
|
3 Months
|
|
Threads:
|
209
|
857
|
2,520
|
|
Post:
|
1,098
|
4,206
|
10,913
|
|
|
Car Audio: General Posting activity graph:
|
Top authors during last week:
user's latest post:
Enlarging sub hole
Published (2009-11-26 22:47:00)
You just happen to have a box that's up to specs, volume & tuning (if applicable) wise for two totally different subs? ...must be sealed. Good luck shaving, keep things round.
user's latest post:
$300 to spend on Subwoofer what...
Published (2009-11-26 18:45:00)
Quote: Originally Posted by andrewtexas123 I gotta disagree with what you say here. First of all its obvious I am not going to send them more money. But you say basicly just give up? Why would I do that if there is still a chance to get me some subs? Andrew Because DCA is known for scamming and you'll end up waiting around forever for subs that very well may never arrive. http://www.caraudioforum.com/vbb3/sh...d.php?t=320390
user's latest post:
Enlarging sub hole
Published (2009-11-26 21:35:00)
sand, sand, sand. or, if you have a steady hand, use a jigsaw to "shave" the edge.
user's latest post:
Midbass/Amps
Published (2009-11-26 07:26:00)
i wouldn't do that, midbass/midrange wave lengths are alot shorter than sub bass, you would get cancellation mixing drivers and the alignment would be wrong. make sure you've sealed your doors off from front to back, alot of people dont and they lack anything above 100-200hz. remember cancellation occurs when you have the same frequency but not in the same phase, the back waves will not be in the same phase as the front, and if...
user's latest post:
Deafeat setting on Alpine 9887
Published (2009-11-26 22:26:00)
Quote: Originally Posted by nauc thats because if you use Defeat, it turns off MX. using MX makes it sound like sh!t MX is crap!
user's latest post:
Email from TC Sounds - Page 2 -...
Published (2009-11-26 18:28:00)
I don't think anyone implied that SQ was limited to the motor. But we were discussing the drivers, specifically, not the entire system. And the surround is part of the suspension last time I looked , and I covered that. It is impossible to discuss the driver's ability to maintain linearity and composure without taking it's suspension into account IMO. Cone material is worth mentioning, I agree. IMO pulp is the only way to go. I...
user's latest post:
amp question
Published (2009-11-26 04:21:00)
Are the subs subs dual 2 or dual 4 ohms?
user's latest post:
Good internet dealer
Published (2009-11-26 23:33:00)
Duties? Most duty on goods imported to Canada went out with the creation of NAFTA back in the 80's .
user's latest post:
Enlarging sub hole
Published (2009-11-26 21:34:00)
What would be the best approach for making a sub hole 1/8" bigger? Hole is 9 1/8" and sub is 9 1/4".
user's latest post:
Email from TC Sounds
Published (2009-11-26 04:27:00)
Quote: Originally Posted by Rare177 awsome to hear they're making a less expensive and power hungry LMS driver. it will still probably force people to clean out their bank accounts to buy the damn drivers though. ever since they stopped targeting the diy crowd it has simple been impossible to afford the TC speakers
|
|
|
|
Latest active threads on Car Audio: General::
Started 2 days, 5 hours ago (2009-11-26 22:07:00)
by basicxj
Nice clean install- kudos for sharing .
Started 3 days ago (2009-11-26 02:41:00)
by pelletier44
Yeah i meant brokerage fees. I bought something that was 89$ from hifi and i paid 43$ brokerage. Wooferset was a 279$ order and i only paid 20$ :-)
Started 3 days, 1 hour ago (2009-11-26 01:29:00)
by sub-standard
If your needing to as 1/8 of an inch, then you will need to shave only 1/16" all the way around. You can usually put a sub in an enclosure that is 1/16" less than the cutout size calls for, it is just a very tight fit & hard to spin. I personally like it better when it's tight that way.
So if you want a tight fit then 1/32" all the way around should do the trick. I would us a tape measure ...
Started 2 days, 8 hours ago (2009-11-26 19:01:00)
by basicxj
X2...no undercoating, no Peel n' Seal. Asphalt bad ...
Started 2 days, 22 hours ago (2009-11-26 04:13:00)
by nabissssco
I know right Anyone who gets that deck knows enough about sounds and features to where they wouldn't use it.
Started 2 days, 5 hours ago (2009-11-26 22:04:00)
by basicxj
Quote:
Originally Posted by lovedoc1
So I have been convinced to lose my rear fill speakers through all of the discussion here. I want to devote my entire amp to my front CDT CL-61A. My current 4-channel is rated at 4x75 at 4Ohm and 2X300 at 4Ohm bridged. By bridgeing the amp to only the front speakers do I lose the ability to fade ...
Started 3 days, 2 hours ago (2009-11-26 00:33:00)
by Rare177
Quote:
Hello,
Here is the latest information on our new products.
Originally, we thought they would be ready to ship the first week of December. Due to some unforeseen material issues that date has changed to the end of January.
We apologize for the delay but want to reassure you that it is well worth the wait.
These are going to be the best...
Started 1 week ago (2009-11-21 19:41:00)
by Bumpin' Goalie
wat are you wanting to accomplish? sq, spl, 50/50?
i usually prefer building a box to fit the needs of a woofer instead of finding woofers to fit a box. however, sometimes it works out well. so how many cubic feet is your box? ported? sealed?
i recommend go look around on www.woofersetc.com for a general idea of best prices.
Started 3 days, 23 hours ago (2009-11-25 04:05:00)
by tripleb45
I will cut deals for tonight only
|
|
Hot threads for last week on Car Audio: General::
Started 1 week, 1 day ago (2009-11-20 21:19:00)
by basicxj
The Alpine CDA 9887 is a unit with significant onboard processing options (the closest thing to the older BassEngine Pro features currently available) that can also use Alpine's Imprint auto-tuning software- be aware that Imprint turns most of the advanced manual tuning features "off".
The CDA 105 is a lesser unit that is dependent on Imprint to set the majority of features up automatically,...
Started 5 days, 7 hours ago (2009-11-23 19:41:00)
by ma_tt316
Loudest might be the CVR but probably not as clean as the German MBQ. Never heard the CDT.
Started 6 days, 7 hours ago (2009-11-22 19:29:00)
by drozzy
Quote:
Originally Posted by slump
Basically I want 4-6 12" subs (around $100 each) in a ported box. I'd like to avoid major upgrades to the electrical system if possible. I'd like to keep the whole system under $2000.
Any suggestions on amps/subs?
First off this "$100 per sub, 4-6 subs" budget sounds a ...
Started 1 week, 1 day ago (2009-11-21 02:53:00)
by only126db
Depends on what 15....
I know those trunks are a pain to get large boxes in due to the opening size.
Started 1 week ago (2009-11-21 17:01:00)
by ma_tt316
I remember asking the same thing about the IDQ a while back. Only diff between the v2 and v3 is pretty much cosmetics for the most part. Either sub will sound good.
Started 1 week ago (2009-11-21 19:41:00)
by Bumpin' Goalie
wat are you wanting to accomplish? sq, spl, 50/50?
i usually prefer building a box to fit the needs of a woofer instead of finding woofers to fit a box. however, sometimes it works out well. so how many cubic feet is your box? ported? sealed?
i recommend go look around on www.woofersetc.com for a general idea of best prices.
Started 5 days, 5 hours ago (2009-11-23 21:23:00)
by Bumpin' Goalie
Started 3 days, 2 hours ago (2009-11-26 00:33:00)
by Rare177
Quote:
Hello,
Here is the latest information on our new products.
Originally, we thought they would be ready to ship the first week of December. Due to some unforeseen material issues that date has changed to the end of January.
We apologize for the delay but want to reassure you that it is well worth the wait.
These are going to be the best...
Started 4 days, 1 hour ago (2009-11-25 01:16:00)
by dibble_brandon
i would go with 6.5" drivers personally, and stay away from oval speakers. i usually only stick to round speakers but thats just personal prefrence.
you can get 5x7 to 6.5" converter plates, ill post a link.
it sayes they will work for a 97-08 Expedition for (front & rear speakers)
http://cgi.ebay.com/ws/eBayISAPI.dll...=263602_263 622
hope this helps
Started 1 week, 2 days ago (2009-11-19 20:10:00)
by bassfreak
with one G id grab a nice comp set and amp.. you could get a nice setup for 850... save another 650 for a woofer and amp..
|
|
Size: 124 bytes
