Chevy Silverado | Forum profile

i have a 2000 sivlerado and i had the same problem i could not find the short in the wire so what i did was jumped off of my trailer wiring harness and they worked ever since good luck

i want to reset the dtc on my truck so i can determine a hard code from and intermittent code. how do i reset? remove cable for ten minutes? use code reader to clear dtc? if i can clear the codes for free would be nice.

If the tail lights are the blade connector type they may be open circuited at the blade wire.Check continuity of the bulb.If no continuity ,replace the bulbs.Then check for power at the blade connector socket with the brake applied.By what you have replaced their should be power their.IF no power ,trace the hot wire to the open circuit or short to ground.

I was driving down the highway and all of a sudden my service 4 wheel drive light came on and i cant figure out why.

2003 Chevrolet Silverado brake lights dont work. Changed bulbs, top cab light comes on when depress the pedal? however, the rear lights dont come on. When I put on the hazards, they flash, (the middle ones) The top ones come on when I remotely lock/unlock doors. I checked the fuse block under BRAKE 10 amp, both in the cab and under the hood, both fuses are good. so if all the bulbs are good, the pedal makes the top cab light go off, all lamps...

I have a 03 silverado 1500 5.3. I have problems starting it. If I jump it and start it every day it will start just fine, but if I leave it for a few days and trying starting it, it wont start so I have to jump it. I have a brand new battery in it. Has anyone else had a problem like this or maybe know what could be wrong?